How to insert the earbuds
20 seconds
1. Choose the correct earbud for each ear.
The letters “R” and “L” indicate the right and
left earbud. Hold the earbud upwards so that
the foam part is down- wards, as shown in
the first picture. When holding the earbud,
squeeze the foam with your other hand a
few times so it softens the foam and it’s
easier to insert in the ear.
2. After softening the foam, insert the
earbud in the same upward position into
the ear. When pressing the earbud into
the ear canal, rotate it backwards at the
same time, in the direction as shown in
the second picture.
3. It is important that the earbud is deep
enough in the ear canal, so remember
to push it in firmly. It takes about 20
seconds for the active noise cancelling
to activate after the earbud is taken out
of the charging case.
4. The active noise cancelling mode activates after 20 seconds once you
have taken the earbuds out from the charging case, You can clearly
hear the active noise cancelling turning on. If you didn’t notice the
change please insert the earbuds back to the charging case and try
inserting them again in the ears within 20 seconds. Also make sure
that the earbuds are charged.
Take the earbuds
from the case
Insert the earbuds
in the ears
Notice the hear-
through mode
Hear how the noise
cancelling starts
