Steelcase Payback – Mounting Overhead Storage to a Desktop Assembly Instructions

Steelcase
Brand
Steelcase
Model
Payback – Mounting Overhead Storage to a Desktop
Type
Assembly Instructions

This manual is also suitable for

ASSEMBLY GUIDE -
OVERHEADS
HARDWARE PACKAGES
Form 7OVHD_P_01-19
NOTE: Actual components may vary in appearance from
the diagram, depending upon unit sizes etc.
DISCARD SHIPPING BOARD
2
5
Cover
1
Expanding
Pin
Camlock (extra)
7HP7
1
Drilling
Template
2
Foam Tape
* *
IMPORTANT
STEP 2 STEP 3
STEP 1
7 O’Clock
Using a #2 Phillips, Rotate
camlock to a minimum
of 7 O’clock to lock.
Level furniture before attaching overhead
ASSEMBLY INSTRUCTIONS
1
2
3
7
Stick Covers over Camlocks
*IMPORTANT*
see below
()
Attach Anti-slip Foam Tape to underside of each
End Panel. Cut away foam at pin holes.
Drill holes in desktop for Pin and Cam attachment
using DRILLING TEMPLATE provided.
.
Insert pins into Overhead end panels, then
carefully set overhead on desktop, aligning pins
with pre-drilled holes.
Lock cam connectors to secure
Overhead to furniture.
8
6
5
4
Remove shipping board by rotating camlocks in
end panels counterclockwise. Retain pins for reuse.
Discard shipping board.
STEP 2 STEP 3
STEP 1
Using a #2 Phillips, Rotate
camlock from 7 O’clock to
12 O’clock to unlock.
7 O’Clock
12 O’Clock
* *
For Shipping
board removal.
**Unsure all 4 camlocks
are unlocked before
removing shipping board!
  • Page 1 1

Steelcase Payback – Mounting Overhead Storage to a Desktop Assembly Instructions

Steelcase
Brand
Steelcase
Model
Payback – Mounting Overhead Storage to a Desktop
Type
Assembly Instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents