Delphi SKYFi2 - XM Vehicle Kit, SA10003 User manual

  • Hello! I am an AI chatbot trained to assist you with the Delphi SKYFi2 - XM Vehicle Kit User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Connecting Delphi XM SKYFi
to Your Vehicle With an FM
Modulator
Connect the red (+) lead to the vehicle
12V power terminal, which is powered
when the ignition is in the accessory
position.
The 12V power connecting cord is
permanently connected for SKYFi
FM
modulation.
The SKYFi name, XM name, and related logos
are trademarks of XM Satellite Radio Inc.
Radio to the power of X
Note: Connect FM modulator ground
terminal to vehicle ground before making any
other connections.
XM Antenna
SKYFi Car Cradle
SKYFi Universal Adaptor
FM Modulator
DELPHI SA 10003
MADE IN MALAYSIA
To ground
Audio In
6V DC In
87.9MHZ
88.5MHZ
88.1MHZ
TO FM
ANTENNA
TO FM
RADIO
12V DC
IN
6V DC
OUT
AUDIO
IN
Frequency switch
+
(red)
(female)
-
(black)
To vehicle
AM/FM
antenna
To vehicle
audio/stereo
To vehicle
12V power
terminal
+
(male) (red)
Turning on the FM Modulator
With ignition in the accessory position, this FM
modulator is always on in a standby condition.
When you turn on your SKYFi Receiver, the FM
modulator will automatically switch the vehicle
stereo input from your FM antenna to an XM
®
Satellite Radio signal.
Changing the Transmitting Frequency
The FM modulator allows you to change the XM
Satellite Radio broadcast signal to an FM
frequency and output the sound to your vehicle
radio via an FM station. You may experience
some interference if a local FM station is broad-
casting at the same frequency. If this occurs,
change your FM modulator frequency using the
switch on the side of the unit. The switch has
three frequency settings: 87.9MHz, 88.1MHz,
and 88.5MHz. Note: Reset the vehicle stereo
frequency to the same value as the FM modula-
tor frequency.
Installation Note: The FM antenna connector
used to connect the FM modulator to the
audio/stereo system may require an additional
adaptor. Some audio/stereo systems have AM
antennas that require an active bias from your
vehicle’s audio/stereo system. If AM reception is
not restored, try a different adaptor that will allow
the active bias to reach the AM antenna.
Professional installation is recommended.
Printed on Recycled Paper
©2003 Delphi Corporation. All rights reserved.
DPSS-03-E-039
/