Pyle PTTCDS7U User manual

Category
Audio turntables
Type
User manual

This manual is also suitable for

CAUTION
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES
CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT
FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
1
1) Please read these instructions and keep them for future reference.
2) Pay attention to all warnings.
3) Follow all instructions.
4) Do not use this apparatus near water.
5) Clean only with a dry cloth.
6) Do not block any ventilation openings.
7) Install in accordance with the manufacturer's instructions.
Do not install near any heat sources such as radiators, heaters, stoves, or other
apparatus (including amplifiers) that produce heat.
8) Protect the power cord from being walked on or kinked, in particular where the
plug is fitted and at the point where it exits from the apparatus.
9) Only use attachments / accessories specified by the manufacturer.
10) Unplug this apparatus during lightning storms or when unused for long periods
of time.
11) Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or
has been dropped.
12) This appliance should not be exposed to dripping or splashing water and no
object filled with liquids, such as vases, should be placed on the apparatus.
13) Do not overload the wall power outlet. Use only power source as indicated - i.e.
120V AC mains.
2
Avoid installing this unit in places exposed to direct sunlight or close to heat radiating
appliances such as electric heaters, on top of other stereo equipment that radiates too
much heat, places lacking ventilation or dusty areas, places subject to constant vibration
and/or humid or moist areas.
Do not attempt to clean this unit with chemical solvents as this might damage the finish. Use
a clean dry cloth.Operate controls and switches as described in the manual.Before turning
On the power, make certain the AC power cord is plugged in. Store your CDs, Cassettes in
a cool area to avoid damage from heat.When moving the set, be sure to first disconnect the
power cord.
Place the unit on a stable, level surface, convenient to an AC outlet, out of Direct
sunlight, and away from sources of excess heat, dust, moisture, humidity or strong
magnetic fields.
IMPORTANT NOTES
PREPARATION FOR USE
3
This product is designed to operate on 120V 60Hz AC Mains only. Attempting to operate
this system from any other power source may cause damage to the system, and such
damage is not covered by your warranty.
NOTE: You will note that this system is equipped with domestic standard AC power 2-pin
plug. If this plug does not fit into your existing
AC outlet, do not try to defeat this safety
feature by filing the wide blade to make
it fit into your outlet. If this plug will not
fit into your outlet, you probably have
an outdated non-polarized AC outlet.
You should have your outlet changed
by a qualified licensed electrician.
AC Plug
AC Outlet
4
5
36
37
38
39
40
41
42
43
44
45
46
CD
USB
SD
FOLDER
6
1.
2.
3.
4.
5.
6.
7.
8.
9.
When you have finished listening to the radio, turn the volume knob in a
counterclockwise direction to switch the unit off. Unplug it from the power supply if
you are not going to use it for a while.
7
1. Open the dust cover and turn the volume knob clockwise to turn the equipment on.
2. Use the function selector to select PHONO mode.
3. Set the speed selector to the appropriate position: 33, 45 or 78, depending on the
record to be played.
4. Set the auto stop control to ON if you want the turntable to stop turning when it has
reached the end of the record. If the switch is set to OFF, the turntable will continue
turning at the end of the record.
5. Place the record on the turntable (use the 45 rpm adaptor, if required).
6. Move the lift lever towards the back to raise the tone arm from the arm park, then slowly
move the arm to the record, as illustrated on the right. The turntable will start rotating.
7. Move the lift lever towards the front, the tone arm will gently drop onto the record and
playback will start.
8
. To stop
playback, move the lift lever towards the back to raise the tone arm. The
turntable will still be rotating but the record will stop playing. To continue playback, move
the lift lever towards the front.
9. To play a different piece on the record, move the lift lever towards the back, move the
raised tone arm to the start of the piece and then move the lift lever towards the front to
lower the tone arm and start playback.
10. To adjust the volume level, turn the volume knob to the right or left.
11. At the end of the record, move the lift lever towards the back to raise the tone arm and
move it back to the tone arm park, and then move the lift lever towards the front to
lowerthe arm onto its rest.
12. Alternatively, lift the tone arm off the record and return it to the arm rest manually.
13. When you hav
e fini
shed playing records, engage the tone arm lock to protect it from
accidental movement. Turn the volume knob in a counterclockwise direction to switch
the unit off. Unplug it from the power supply if you are not going to use it for a while.
8
1.
2.
3.
4.
5.
6.
7.
1. Turn the volume knob clockwise to turn the equipment on.
2. Use the function selector to select TAPE/AUX mode.
3. Insert a cassette with the tape facing away from you, as illustrated on the right.
The EJECT/FAST FORWARD button will pop out and the system will start playing
the tape automatically.
4. Turn the volume knob to your desired level.
5. To fast forward the cassette tape, press the EJECT/FAST FORWARD button
halfway down while the cassette is playing. The tape will be advanced forward rapidly.
6. To resume normal playback, slightly press the EJECT/FAST FORWARD button again.
The button will fully pop out again.
7. To stop playback, press the EJECT/FAST FORWARD button completely. Playback
will be stopped and the cassette tape will be ejected.
9
1.
2.
3.
4.
5.
10
1.
2.
3.
4.
5.
5.
1.
11
2.
3.
4.
12
1.
2.
3.
4.
5.
6.
7.
13
1.
2.
3.
4.
1.
2.
3.
4.
5.
1.
2.
3.
4.
14
1.
2.
3.
1.
2.
3.
4.
1.
2.
(USB drive, SD or MMC card).
15
3.
1.
2.
3.
1.
16
2.
3.
4.
5.
17
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20

Pyle PTTCDS7U User manual

Category
Audio turntables
Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI