Page is loading ...
Cleveland
™
P
roject ________________________________
Item __________________________________
Quantity _______________________________
F
CSI Section ____________________________
A
pproval _______________________________
D
ate __________________________________
1333 East 179 St.,
Cleveland, Ohio, U.S.A. 44110
Tel: 1-216-481-4900
Fax: 1-216-481-3782
Web Site: www.ClevelandRange.com
Email: Steam@ClevelandRange.com
COOK CHILL SYSTEMS
Cook/Chill Systems
SECT. XIV PAGE 41
0609
AIR COOLED
CONDENSING UNITS
MODELS:
T-075M8
BLV-2500C6
JLD-5000C6
T-100M8
BLV-3000C6
JLD-6000C6
BLV-1500C6
BLV-3500C6
JLD-7000C6
BLV-2000C6
BLV-4000C6
JLD-8000C6
Cleveland Standard Features
I Air cooled condensing unit for outdoor installation
I For operation with R-22, 404A or R507 refrigerant
(please specify)
I Liquid line filter with replaceable core and sight glass
I High efficiency Copeland discus compressor
I Galvalume weather housing with raised base compressor
I Thermally protected
I Permanently lubricated condenser fan motor(s)
I Access panels for easy servicing of internal components
I Electrical controls are mounted in control box with hinged
door
I Receivers include service valves
I Suction and discharge vibration eliminators
I 180 lbs. head pressure valve
I Crankcase heater for cold temperature operation
I Suction filter with replaceable core
I Suction accumulator
I Oil separator
I Low ambient kit
I Anti short cycle timer
I Liquid line solenoid valve (shipped loose)
I Dry contacts for compressor alarm
I Accepted for use in U.S.D.A. Inspected Facilities
Options & Accessories
Ë Water Cooled Condensing Units
Ë Larger models available upon request
Ë Extended four (4) year compressor warranty
(domestic only)
Ë Ice Water Control Panel for location in production area
Ë Ice Builders
Shall be CLEVELAND, Model _____________ , Outdoor, ____ HP,
AIR COOLED CONDENSING UNIT for Ice Builder. Weather hous-
ing with raised Base Compressor; Receiver with Discharge and
Suction Line Vibration eliminators; Pressure Control; Drier//Sight
Glass Kit; Liquid Line Solenoid Valve; replaceable Core Suction
Line Filter, Suction Line Accumulator; Oil Separator and Oil Failure
Safety Control; Head Pressure Control Valve; Control Panel with
hinged door housing Low Ambient Kit, Compressor Contactor,
and Control Circuit Fusing.
Short Form Specifications
SECT. XIV PAGE 42
0609
Litho in USA
Cleveland Range reserves right of design improvement or modification, as warranted.
REAR VIEW
T-075M8 thru T-100M8
A
35 3/8"
B
C
55 5/8"
BLV-1500C6 thru BLV-4000C6
REAR VIEW
PLAN VIEW
44 1/2"
SUCTION
LINE
LIQUID
L
INE
LINE
S
UCTION
LIQUID
LINE
KNOCKOUTS
FOR
ELECTRICAL
CONNECTIONS
39 1/8"
FUSED
DISCONNECT
SWITCH
SIDE VIEW
PLAN VIEW
REAR VIEW
PLAN VIEW
55 5/8"
D
87 1/16"
JLD-5000C6 thru JLD-8000C6
LINE
SUCTION
LINE
L
IQUID
K
NOCKOUTS
F
OR
E
LECTRICAL
CONNECTIONS
KNOCKOUTS
FOR
ELECTRICAL
C
ONNECTIONS
JLD units have two (2)
compressors and are not
supplied with fused disconnects.
MINIMUM CLEARANCE
FRONT 24" MIN
SIDE 24" MIN
REAR 24" MIN
DIMENSIONS
CONDENSING ICE SHIPPING
UNIT BUILDER WEIGHTS
MODEL MODEL AB C DLBS / KG
T-075M8 IBC-50 67 3/4" ---1,140 / 517
T-100M8 IBC-75 67 3/4" ---1,330 / 603
BLV-1500C6 IBC-100 - 170 3/4" --1,900 / 862
BLV-2000C6 IBC-125 - 170 3/4" --1,980 / 898
BLV-2500C6 IBC-150 - 225 3/4" --2,170 / 984
BLV-3000C6 IBC-175 - 225 3/4" --2,260 / 1,028
BLV-3500C6 IBC-200 --225 3/4" - 2,760 / 1,025
BLV-4000C6 IBC-250 --225 3/4" - 2,860 / 1,297
JLD-5000C6 IBC-300 -- -226" 4,060 / 1,842
JLD-6000C6 IBC-350 -- -226" 4,520 / 2,050
JLD-7000C6 IBC-400 -- -226" 5,520 / 2,504
JLD-8000C6 IBC-450 & 500 -- -226" 5,720 / 2,595
UTILITY CONNECTIONS ELECTRICAL 208 / 3PH
CONDENSING RECEIVER COMPRESSOR CONDENSER TOTAL
UNIT CAPACITY LIQUID SUCTION RATED FAN MOTOR AMP
MODEL LBS LINE LINE LOAD AMPS QTY LOAD
T-075M8 162 1/2" 1 1/8" 28.3 2 38.1
T-100M8 227 7/8" 1 3/8" 39.1 2 54.3
BLV-1500C6 274 7/8" 1 5/8" 59.9 2 82.5
BLV-2000C6 615 7/8" 1 5/8" 66 2 90.5
BLV-2500C6 615 1 1/8" 2 1/8" 82.8 2 116.8
BLV-3000C6 615 1 1/8" 2 1/8" 94 2 131.5
BLV-3500C6 615 1 1/8" 2 1/8" 107 3 154.8
BLV-4000C6 615 1 1/8" 2 1/8" 142 3 198.5
JLD-5000C6 (2) 369 1 1/8" 2 1/8" * 82.2 4 201.0
JLD-6000C6 (2) 369 1 1/8" 2 1/8" * 94 4 216.0
JLD-7000C6 (2) 615 1 1/8" 2 1/8" * 107 4 256.0
JLD-8000C6 (2) 615 1 1/8" 2 1/8" * 142 4 326.0
*PER COMPRESSOR
REFRIGERANT NOT SUPPLIED BY CLEVELAND RANGE.
AIR COOLED CONDENSING UNITS ARE FOR OUTDOOR INSTALLATION.
WATER COOLED CONDENSING UNITS ARE FOR INDOOR INSTALLATION.
(NOT TO SCALE)
/
