Viking Range Insulated Jacket For 54" Gas Grills Installation guide

Type
Installation guide

Viking Range Insulated Jacket For 54" Gas Grills is an accessory designed to enhance the functionality and safety of your gas grill. The insulation helps to maintain consistent cooking temperatures, reducing heat loss and improving efficiency. The jacket also provides a protective barrier around the grill, minimizing the risk of accidental burns or injuries. Additionally, the insulated jacket can help to reduce noise levels, making your grilling experience more enjoyable.

Viking Range Insulated Jacket For 54" Gas Grills is an accessory designed to enhance the functionality and safety of your gas grill. The insulation helps to maintain consistent cooking temperatures, reducing heat loss and improving efficiency. The jacket also provides a protective barrier around the grill, minimizing the risk of accidental burns or injuries. Additionally, the insulated jacket can help to reduce noise levels, making your grilling experience more enjoyable.

1
Installation
MANUAL
5 SERIES
Insulated Jacket
VIJ5 301
VIJ5 361
VIJ5421
VIJ5541
2
IMPORTANT: Before you build the frame, you must take into consideration the total weight of the liner, grill
and any  nishing materials.
Refer to the cutout dimension table for the proper framing dimensions for the insulation jacket. Determine
the entry point for both the gas inlet and electrical connections. Make the 4” square holes for gas and
electrical connections (rear or bottom access) based on your requirements.
Note: that the electrical connections are located on the left side and the gas connections are located on the
right side.
A Carpenter’s spirit level” should be used to assure that the framing is level, both front to back and side to
side. Note: Never under any circumstance should you install the transformer or run a quick disconnect hose
inbetween the grill and the inside of the insulating jacket.
Liner Installation
Position the liner into the frame. No part of the combustible enclosure can protrude above the top surface
or in front of the face surface of the liner. Shim the liner if necessary.
Use the proper equipment to support the grill. Place the grill into the liner and engage it over the liner lip
across the back and sides. The liner is designed to support the grill without additional fasteners.
Grill Installation
If desired any gap remainng between the liner and the combustible enclosure may be  lled with a non-
combustilble sealant or caulk.
3
Cutout Dimensions
A
C
B
4” square holes for gas and electrical
connections both left and right sides
(rear or bottom access). Make these
holes in the frame based on your
requirements
MODEL A B C
VIJ5301 36.00 11.63 26.50
VIJ5361 42.00 11.63 24.00
VIJ5421 48.00 11.63 26.50
VIJ5541 60.00 11.63 26.50
4
VIJ5301
Insulated Jacket Dimensions
TOP VIEW
FRONT VIEW SIDEVIEW
29-1/4”
(74.3 cm)
3-1/4”
(8.3 cm)
3-1/4”
(8.3 cm)
35-3/4”
(90.8 cm)
26-3/8”
(67.0 cm)
3-1/4”
(8.3 cm)
3-1/4”
(8.3 cm)
29-1/4” (74.3 cm)
35-3/4” (90.8 cm)
11-5/8”
(29.5 cm)
11-5/8”
(29.5 cm)
25” (63.5 cm)
26-3/8” (67.0 cm)
1-3/8”
(3.5 cm)
3/4”
(1.9 cm)
5
VIJ5361
41-3/4” (106.0 cm)
23-5/8” (60.0 cm)
1-3/8”
(3.5 cm)
TOP VIEW
FRONT VIEW SIDEVIEW
35-1/4”
(89.5 cm)
3-1/4”
(8.3 cm)
3-1/4”
(8.3 cm)
41-3/4”
(106.0 cm)
23-5/8”
(60.0 cm)
3-1/4”
(8.3 cm)
3-1/4”
(8.3 cm)
35-1/4” (89.5 cm)
11-5/8”
(29.5 cm)
11-5/8”
(29.5 cm)
22-1/4” (56.5 cm)
3/4”
(1.9 cm)
6
VIJ5421
3-1/4”
(8.3 cm)
47-3/4”
(121.3 cm)
26-3/8”
(67.0 cm)
3-1/4”
(8.3 cm)
41-1/4”
(104.8 cm)
TOP VIEW
FRONT VIEW SIDEVIEW
3-1/4”
(8.3 cm)
3-1/4”
(8.3 cm)
47-3/4” (121.3 cm)
41-1/4” (104.8 cm)
11-5/8”
(29.5 cm)
25” (63.5 cm)
1-3/8”
(3.5 cm)
3/4”
(1.9 cm)
26-3/8” (67.0 cm)
11-5/8”
(29.5 cm)
7
VIJ5541
3-1/4”
(8.3 cm)
59-3/4”
(151.89 cm)
26-3/8”
(67.0 cm)
3-1/4”
(8.3 cm)
53-1/4”
(135.3 cm)
TOP VIEW
FRONT VIEW SIDEVIEW
3-1/4”
(8.3 cm)
3-1/4”
(8.3 cm)
59-3/4” (151.89 cm)
53-1/4” (135.3 cm)
11-5/8”
(29.5 cm)
25” (63.5 cm)
1-3/8”
(3.5 cm)
3/4”
(1.9 cm)
26-3/8” (67.0 cm)
11-5/8”
(29.5 cm)
Viking Range, LLC
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information, call 1-888-(845-4641) or visit our web site at vikingrange.com
072267-000
A EN (022820)
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Viking Range Insulated Jacket For 54" Gas Grills Installation guide

Type
Installation guide

Viking Range Insulated Jacket For 54" Gas Grills is an accessory designed to enhance the functionality and safety of your gas grill. The insulation helps to maintain consistent cooking temperatures, reducing heat loss and improving efficiency. The jacket also provides a protective barrier around the grill, minimizing the risk of accidental burns or injuries. Additionally, the insulated jacket can help to reduce noise levels, making your grilling experience more enjoyable.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI