1
INSTRUCTIONS MANUAL
2-LIGHT SEMI-FLUSH LIGHT FIXTURE
ADDISON COLLECTION
HOME DEPOT SKU# 570-737 (UPC#802513147926)
2
Thank you for purchasing this Hampton Bay interior Semi-Flush light
fixture. This product has been manufactured with the highest standards
of safety and quality.
FEATURES:
1. Easy to install.
2. Two light semi-flush light fixture with Oil Rubbed Bronze finish and
Tiffany Shade.
3. For energy savings this fixture has been engineered to safely use a Self
Ballasted Compact Fluorescent Bulb in place of an incandescent bulb.
QUESTIONS, PROBLEMS, MISSING PARTS:
Before returning to your local Home Depot, please call our Customer
Service Team at 1-877-527-0313 or visit www.homedepot.com. Please
reference your SKU 570-737 or UPC (802513147926)
3
CAUTION:
1. Before starting installation of this fixture or removal of a previous
fixture, disconnect the power by turning off the circuit breaker or by
removing the fuse at the fuse box.
2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY
ELECTRICAL QUESTIONS. If you have any non-electrical
questions about this fixture, please call our Customer Service Team at
1-877-527-0313 or visit www.homedepot.com
. Please reference your
SKU (570-737) or UPC (802513147926).
3. KEEP your receipt and these Instructions for Proof of Purchase.
TOOLS REQUIRED FOR INSTALLATION AND ASSEMBLY
(not included):
Phillips
screwdriver
Flathead
screwdriver
Safety
goggles
Wire
cutters
Wire
strippers
Electrical
tape
Light Bulb
(Maximum 60 watt Medium
Base Incandescent Bulb
or CFL equivalent)
4
PARTS INCLUDED FOR ASSEMBLY AND INSTALLATION
(parts are not to scale):
Parts Qty
Hex Nut 2
Support Screw 2
Threaded Tube 1
Wire Connector 3
Outlet Box Screw 2
Green Ground Screw 1
Mounting Strip 1
Cap Nut 2
Washer 1
Finial 1
Shade 1
Fixture Body 1
5
ASSEMBLY AND INSTALLATION DRAWING:
HEX NUT
SUPPORT SCREW
BARE COPPER
OUTLET BOX SCREW
GREEN GROUND SCREW
WIRE CONNECTOR
MOUNTING STRIP
OUTLET BOX
BLACK SUPPLY WIRE
WHITE SUPPLY WIRE
GROUND SUPPLY WIRE
CANOPY
SHADE
WHITE WIRE
BLACK WIRE
GROUNDING WIRE
CAP NUT
BUSHING
THREADED TUBE
FIXTURE BODY
6
ASSEMBLY AND INSTALLATION INSTRUCTIONS:
1. Shut down the main electrical supply from the fuse box or circuit breaker in your house or building.
2. Tighten support screws (long) full turns into the inside mounting hole of mounting strip (to be fully
tightened later) secure by hex nut. This support screws (long) should extend long enough to protrude
through the canopy when it is mounted.(Adjust as needed)
3. Fasten the mounting strip onto outlet box using two outlet box screws (short).
4. Connect the wire from the fixture to the power supply wire from outlet box. Cover with wire connectors.
A. Twist together white wire from the fixture with white wire from outlet box. Cover with wire connector.
B. Twist together black wire from the fixture with black wire from outlet box. Cover with wire connector.
C. The bare copper grounding wire from the fixture must loop one turn under the head of green screw on
mounting strip before it is connected to the grounding conductor of the supply circuit.
5. Carefully position all wiring inside outlet box.
6. Place the canopy over the outlet box, let the heads of support screws (long) come through the holes of the
canopy, then tighten the cap nuts to the protruding support screws on mounting strip until the canopy is
held firmly against the ceiling.
7. Install the bulbs (not included). Use 60-watt Maximum standard type A bulbs or MAX 13W UL
LISTED CFL bulb.
8. Screw the threaded tube into the bushing located on socket assembly, Place the washer and shade through
the threaded tube and secure by tightening the finial.
9. Turn on the electrical power in your house or building to activate the semi-flush light fixture.
7
TROUBLESHOOTING:
Possible Cause Corrective Action
1. Power is off. 1. Make sure power supply is on.
2. Faulty switch. 2. Test or replace switch.
Lights will not turn on.
3. Faulty wire connection. 3. Check wiring.
Fuse blows or circuit breaker
trips when light is turned on.
1. Crossed wires or power wire is grounding
out.
1. Check wire connections.
PRODUCT MAINTENANCE:
1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean
water, never a solvent) to wipe the surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning off the
circuit breaker or by removing the fuse at the fuse box. Next, use a dry or slightly dampened
clean cloth (use clean water, never a solvent) to wipe the interior surface of the fixture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft
cloth to dust or wipe carefully.
LIMITED WARRANTY
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a
period of five (5) years from date of purchase. This warranty applies only to the original consumer purchaser and
only to products used in normal use and service. If this product is found to be defective, the manufacturer’s only
obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s
discretion, provided that the product has not been damaged through misuse, abuse, accident, modifications,
alterations, neglect or mishandling. This warranty shall not apply to any product that is found to have been
improperly installed, set-up, or used in any way not in accordance with the instructions supplied with the product.
This warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence,
alteration, or faulty installation, or any other failure not relating to faulty material or workmanship. This
warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as this is
considered normal wear and tear. The manufacturer does not warrant and specially disclaims any warranty,
whether expressed or implied, of fitness for a particular purpose, other than the warranty contained herein.
The manufacturer specifically disclaims any liability and shall not be liable for any consequential or
incidental loss or damage, including but not limited to any labor/expense costs involved in the replacement
or repair of said product.
8
MANUAL DE INSTRUCCIONES
LÁMPARA DE 2-LUCES SEMI-INCRUSTADA EN EL TECHO
COLECCIÓN ADDISON
HOME DEPOT SKU# 570-737 (UPC#802513147926)
Page is loading ...
Page is loading ...
Page is loading ...
12
DIBUJO DE INSTALACIÓN Y ENSAMBLAJE:
TUERCA HEXAGONAL
TORNILLO DE SOPORTE
ALAMBRE DE COBRE
TORNILLO CAJA DE EMBUTIR
TORNILLO VERDE A TIERRA
CONECTOR DE ALAMBRE
BARRA DE MONTAJE
CAJA DE EMBUTIR
ALAMBRE NEGRO DE
ALAMBRE BLANCO DE
ALAMBRE A TIERRA DE LA
DOSEL
TUERCA DE TAPA
CASQUILLO
NIPLE DE MONTAJE
PANTALLA
ALAMBRE BLANCO
ALAMBRE NEGRO
FUENTE DE ELECTRICIDAD
DESNUDO A TIERRA
FUENTE DE ELECTRICIDAD
FUENTE DE ELECTRICIDAD
CUERPO DEL ARTEFACTO
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
19
ASSEMBLAGE ET INSTALLATION :
Page is loading ...
Page is loading ...
/
