!
WARNING
This infant car seat adapter is for use ONLY on the Joovy Zoom Joggers. DO NOT use on other stroller models.
This infant car seat adapter is for use ONLY with the Graco® infant car seat models identied below. DO NOT use other infant car seat models.
ALWAYS install the infant car seat so that the child is facing toward the rear (handlebar) of the stroller.
ALWAYS position the infant car seat so that it securely snaps into place inside the infant car seat adapter frame.
!
WARNING
Before each use, check to make sure all four clamps are secure and all Velcro® straps are fully attached.
Installing/Using the Infant Car Seat Adapter
• UnsnapthevesnapslocatedonBOTHsidesoftheseat.See Figure 1.
• Foldthefabricinsideandunderthestrollerframetubessothatthetubesareclearlyexposedonbothsidesofthestroller.See Figure 2.
• Positionthecanopysoitisopenedhalfway.Reclinetheseattoitsmaximumreclineposition.See Figure 3.
• RemovetheVelcro®strapsfromeachclamp,thenopenallfourclampsontheadapter.
• Placethecarseatadapteronthestrollerframetubessothatthecanopyhingebracketsarebetweentheadapterclamps.See Figure 4.
DO NOT allow any of the seat fabric to be captured by the clamp.
• Closeallfourclampsaroundthestrollerframetubes.See Figure 5. Makesurethatallfourclampsarefullyclosedandnoseatfabricis
capturedbytheclamps.
• InserttheloopendofoneVelcro®strapbetweenoneadapterclampandtheseatfabric.Attachthelooparoundthetabontheclamp.
See Figure 6.
• WraptheVelcro®straptightlyaroundtheclamp.See Figure 7.
• EnsurethatthemiddleloopoftheVelcro®straptsovertheclamptab. See Figure 8.
• ContinuewrappingtightlyuntiltheentirelengthoftheVelcro®strapissecuredtogether.MakesuretheedgesoftheVelcro®strapare
alignedformaximumstrength.See Figure 9.
• RepeatfortheotherthreeclampsandVelcro®straps.
• Closethecanopycompletely.
NOTE: Tomaximizespaceforyourbaby,attachthetwosetsofsnapsfoundontheundersideofthecanopy.See Figure 10.
• PlacetheGraco®infantcarseat(sothecarseatfacesthehandlebar)intotheadapteruntilthecarseatsnapsintoplace.Pulluponthecar
seattoensureitissecure.See Figure 11.
• Toremovetheinfantcarseat,pullthereleaselever(sameleverusedtoreleasethecarseatfromitsbase)andliftup.
NOTE: strollerfoldswithcarseatadapterinstalled.
Removing the Infant Car Seat Adapter
• Toremovethecarseatadapter,rstpositionthecanopysothatitisopenedhalfway.
• RemoveallfourVelcro®strapsfromtheclamps.
• Openallfourclampsandremovetheadapterfromthestroller.
• ReattachthefourVelcro®strapstotheclampsontheadapterandstoretheadapterforfutureuse.
• WraptheseatfabricoverthestrollerframetubesandreattachthevesnapslocatedonBOTHsidesofthestroller.
Zoom
Graco® Car Seat Adapter
00948
GRACO® CAR SEAT ADAPTER COMPATABILITY
Graco® Classic Connect