Dometic 3106863.214B User manual

  • Hello! I'm a chat assistant that has analyzed the provided document. This document provides installation instructions for Dometic Door Panel Inserts, specifically models 3106863.214B, 3106863.214C, and 3313470.164, intended for use in RV refrigerators, model DMH1072. The document includes information on how to remove existing trim, install panels and new trims. I'm ready to answer your questions about this document and the related products.
  • Where are the refrigerator door trim pieces located?
    What should I do if a trim piece is damaged during removal?
    What is the first step if I am installing accessory kit 3313470.164?
    What should I do if I am installing accessory kit 3106863.214B or 3106863.214C?
INSTALLATION INSTRUCTIONS
USA
SERVICE OFFICE
Dometic Corporation
1120 North Main Street
Elkhart, IN 46514
SERVICE CENTER &
DEALER LOCATIONS
Visit:
www.eDometic.com
REVISION C
Form No. 3316503.000 07/18
(French 3316504.000_C)
©2018 Dometic Corporation
LaGrange, IN 46761
Door Panel Inserts
Accessory Kits 3106863.214B, 3106863.214C, 3313470.164
Refrigerator Model DMH1072
Read these instructions carefully. These instructions MUST stay with this product.
INTRODUCTION
These Door Panel Insert Accessory kits are designed and intended for installation in new refrigerators or as a replacement for
existing door panels in a Recreational Vehicle during or after the RV manufacture.
Read these instructions before starting the installation.
Dometic Corporation reserves the right to modify appearances and specications without notice.
INSTALLATION
A. Removing The Door/Drawer Side Trim (If Required)
STEP 1
Trim
Frame
Putty
Knife
Screwdriver
The refrigerator door trim pieces can be found attached to the cooling unit in the rear of the refrigerator.
If a trim piece is damaged during removal, contact Dometic customer service for replacement service kit # 3315734.900.
All manuals and user guides at all-guides.com
2
INSTALLATION
B. Installing The Door/Drawer Panels
If you are installing accessory kit 3313470.164, proceed with Step 1.
If you are installing accessory kit 3106863.214B or 3106863.214C, skip to Step 2.
STEP 1 Remove
Adhesive
Backing
Cardboard
Spacer
Centered
On Door
Cardboard
Spacer
Centered
On Drawer
Cardboard
Spacer
Firmly push the cardboard spacer against the refrigera-
tor to attach.
STEP 2
Door
Panel
Door
Drawer
Properly
Positioned
Panel
Drawer
Panel
Make sure the panels are positioned behind the top,
bottom, and side trim pieces.
C. Installing The Door And Drawer Side Trim
STEP 1
Top View
Door Frame
Panel Insert
Trim
Start by placing the leading edge of the side trim against
the trim on the panel insert and apply inward pressure to
snap the trim into position as required.
STEP 2
Gently Tap
Trim To Snap
Into Position
Trim
Trim
All manuals and user guides at all-guides.com
/