Toolots XCD-90B User manual

Operation instruction for changing door hinge of XCD-90B

(changing from left to right hinge)

1. Part list required to change the door hinge

A: upper right hinge B: left handle assembly C:right trim panel

2. Remove the fixing screw of the upper left hinge Dand remove the door

3. Remove right handle assembly Eand left trim panel Fof the door. Then install the corresponding left

handle assembly Band right trim panel Cof the door. Put the door in place for subsequent installation.

Installation status before changing Installation status after changing

4. Remove the decoration box Gand the handle lock Hof the control panel. Then install them to the

corresponding position on the other side of control panel.

Installation status before changing

Installation status after changing

5. Install the upper right hinge Conto the right side of the cabinet.

6. Put the cabinet down. Remove the left lower hinge Iand right lower hinge J.

7. Place the door with replaced handle and trim panel onto the cabinet. Install the lower left hinge Iand the

lower right hinge Jafter the door is put in the center of the cabinet. Do not forget to install the nylon gasket

on the hinge shaft, otherwise the door will be sagging.

Installation status before changing Installation status after changing

8. After installing the door, stand the cabinet up. Then check whether the door handle and lock fit properly

and whether the door seal is tight. The replacement of door hinge is completed if there is no problem with the

above inspection.

Installation status before changing Installation status after changing