Operating Instructions - Dishwasher Smeg DI112-1
Control panel
Note: Your dishwasher’s control panel is on the top lip of the door. You may need to open the door to see the control
panel. This is just a guideline and may vary depending on the model.
1. ON/OFF Button
2. Selected program indicator lights
3. Program selection button
4. Water hardness adjustment indictor light/ salt warning light
5. Rinse aid warning light
6. Options
Loading the dishwasher
Before loading the racks remove all food residues, arrange the crockery so that it is held in place firmly and doesn’t tip
over.
Program table
Detergent
The detergent dispenser must be refilled at the start of each wash cycle.
• Open the detergent cap and place the detergent inside the dispenser. Shut the
detergent dispenser cap.
• During the washing cycle the dispenser will be opened automatically.
Starting a wash program
1. Load the dishwasher.
2. Add detergent
3. Turn the appliance on by using the ON/OFF button and wait for the program indicator light to illuminate.
4. Press the program selection button until the indicator light corresponding to the desired program illuminates.
5. Select the option required
6. Close the door firmly. The washing will start after a few seconds.
Changing the wash program
To change the program in progress, open the door and select a new program. When the door is closed the dishwasher
will automatically change to the new programme.
Cancelling the current program
1. To cancel the selected program open the door and hold the program selection button for a few seconds until the
last two indicator lights illuminate simultaneously (marked ‘end’).
2. Close the door
3. After 1 minute the dishwasher will advance to the end of the cycle.
At the end of a wash program
1. At the end of the program the beeper sounds briefly and the last two indicator lights flash (marked ‘end’).
2. To switch off the dishwasher, open the door and press the ON/OFF button.
-
1
-
2
