2. Spyder
  3. ALT-YD-JW19-SEQ-All
ALT-YD-JW19-SEQ-All

Spyder ALT-YD-JW19-SEQ-All Installation guide

  • Hello! I've reviewed the installation guide for the Spyder LED tail lights model ALT-YD-JW19-SEQ-(All). This document provides a step-by-step process for installing these lights, including the tools needed and how to connect the wiring. I'm ready to answer your questions about any part of the process described in the guide or about the product.
  • What tools are needed for installation?
    What is the first step in the installation?
    What should I do after installing the new tail light?
INSTALLATION GUIDE:
ALT-YD-JW19-SEQ-(All)
Tools Needed:
• ¼” ratchet
• 10mm socket
• Panel popper
• Phillips screw driver
1. Remove plastic cover using panel popper.
2. Remove 10mm tail light retainer.
4. Disconnect wire harness clip.
3. Unseat tail light.
6. Carefully remove bracket from tail light.
7. Place bracket on Spyder tail light and
install (3x) Phillips screws.
8. Clip Spyder wire harness connector onto
bracket.
5. Remove (3x) Phillips screws securing
bracket to old tail light.
8. Connect wire harness.
9. Seat Spyder tail light.
12.Turn on lights and confirm all functions
are working properly. You have successfully
completed the install of your new Spyder
LED tail lights.
10. Reinstall 10mm tail light retainer.
11. Reinstall plastic cover.
For further help with installation, please watch our installation video.
Follow the direct link below to our YouTube channel for more
information:
http://www.youtube.com/watch
DISCLAIMER
Spyder Auto Installation Guide is not liable for damages, injuries, and death while
installing the product. This is intended to be an installation guide, to reduce
installation time. We have no responsibility for improper installation. If you do not
know how to install, please have a professional install it.
/