Ambient Weather WEATHERMOUNT Owner's manual

Brand
Ambient Weather
Model
WEATHERMOUNT
Category
Wall & ceiling mounts accessories
Type
Owner's manual

Ambient Weather WEATHERMOUNT is a flexible mounting alternative for weather stations. It can be mounted on a pitched surface, flat roof, or vertical surface. The mount angles 11" in the horizontal direction to allow clearance of eaves or roof overhangs. Constructed from powder-coated steel and includes a galvanized aluminum mast, this mount is strong, durable, and stable. WEATHERMOUNT is easy to install and comes with all necessary hardware.

Ambient Weather WEATHERMOUNT is a flexible mounting alternative for weather stations. It can be mounted on a pitched surface, flat roof, or vertical surface. The mount angles 11" in the horizontal direction to allow clearance of eaves or roof overhangs. Constructed from powder-coated steel and includes a galvanized aluminum mast, this mount is strong, durable, and stable. WEATHERMOUNT is easy to install and comes with all necessary hardware.

Page 1
Ambient Weather
6845 W. Frye Road
Chandler, AZ 85226
TEL 480-346-3380 l FAX 480-346-3381
www.AmbientWeather.com
Ambient Weather WeatherMount Installation Manual
Figure 1
The Ambient Weather WeatherMount is a flexible
mounting alternative to a mounting pole or tripod.
The mounting plate provides a fast and easy
installation, and can be mounted on a pitched
surface, flat roof or vertical surface, such as a gable.
The WeatherMount is constructed from powder
coated steel and includes a galvanized aluminum
mast. This mounting system is strong, durable and
stable. The slender design is simple, unobtrusive
and aesthetically pleasing. The base can be adjusted
to mount on any pitched roof. Works great with any
weather station.
The small base footprint 4-3/4" W x 7" H (mounting
point foot print 3.75" x 6") allows four lag screws
(included) to be easily mounted at the apex of your
gable. The mount angles 11" in the horizontal
direction to allow clearance of eve or roof
overhangs. Out of the box, the overall height is
approx. 49”.
Add one or more mast extensions (EZ-125-35M) to
increase the height of the mounting assembly by 35"
per mast (reference the "May we also suggest"
section below).
We ship this item in two configurations
depending on the item(s) on each order.
Configuration 1, most common: Includes one j-
pipe section and three assemblable 14" x 1.25"-
diameter masts. Add a mast extension (see below)
to extend the pole an additional 31".
Configuration 2: Includes one j-pipe section
assembled with one 35" x 1.25"-diameter smooth
mast. Add a mast extension (see below) to extend
the pole an additional 31" per extension.
The weather station pictured is not included.
Page 2
Ambient Weather
6845 W. Frye Road
Chandler, AZ 85226
TEL 480-346-3380 l FAX 480-346-3381
www.AmbientWeather.com
Components
The WeatherMount assembly includes the following components:
1 J-pipe
1 Mounting bracket
1 Carriage bolt
1 7/16” Hex bolt
2 7/16” Hex lock nuts
4 Lag Screws
2 Tar Pads
Figure 1
Tools and Materials Needed
• Level or Plumb
• Drill
• Adjustable wrench
Important Installation Instructions
CAUTION: Improper installation of the
WeatherMount to your roof top may result in
leaks. We recommend a licensed roofing
specialist for evasive installations.
CAUTION: Any metal object may attract a
lightning strike, including your weather station
and tripod.
Never install your weather station in a
thunderstorm.
We recommend properly grounding the tripod to
avoid extensive damage to the weather station
and structure. Consult a licensed electrician or
local lightning detection expert prior to installing
a ground wire.
WeatherMount Installation
Reference Figure 2. There are three typical
mounting configurations (1) pitched roof mount
(2) flat roof mount (3) gable end mount
(horizontal).
Figure 2
Step 1. Fasten the WeatherMount base to the
building, home or structure (Figure 4). Use the
enclosed lag screws to drill into the structure. If
drilling into a non masonry structure, use the
included tar pad kits (tar pad kits are not
intended to be used when mounting using the
optional accessory Ubolts).
Page 3
Ambient Weather
6845 W. Frye Road
Chandler, AZ 85226
TEL 480-346-3380 l FAX 480-346-3381
www.AmbientWeather.com
Figure 4
Step 2: Rotate the base of the pole until it is
vertically level. Use a level to make certain
the top of the mounting pole is level and
tighten the adjustable bracket.
Step 3: Mount the weather station to the
mounting pole, if you received
Configuration 1 see step 4 below. Note, if
it is a wireless weather station, it is
recommended the solar transmitter(s) is
facing true south.
Figure 5
Step 4: Reference the figure above. Insert one
of the swaged ends into the top of the J-pipe
assembly and tighten, by applying rotational
force (hand tight is usually enough), so the
extension does not rotate loose when
permanently installed.
Repeat this step for the second and third 14”
mast.
Page 4
Ambient Weather
6845 W. Frye Road
Chandler, AZ 85226
TEL 480-346-3380 l FAX 480-346-3381
www.AmbientWeather.com
EZ-125-35M 35” Mast Extension (Optional)
Galvanized 1-1/4 inch (3.25 cm) O.D., 35 inch
(89 cm) long steel post with one end crimped for
insertion into another post of the same O.D.
Made of 18 gauge 1008-10 steel tubing,
galvanized using the Flo-Coat (zinc-chromate-
polymer) process for excellent corrosion
protection.
Figure 6
Mast Extension Installation
Figure 7
Figure 7. Insert the swaged end of the mast
extension into the mounting tripod mast and
tighten so the extension does not rotate.
Repeat this step for additional mast extensions
(maximum two is recommended).
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Ambient Weather WEATHERMOUNT Owner's manual

Brand
Ambient Weather
Model
WEATHERMOUNT
Category
Wall & ceiling mounts accessories
Type
Owner's manual

Ambient Weather WEATHERMOUNT is a flexible mounting alternative for weather stations. It can be mounted on a pitched surface, flat roof, or vertical surface. The mount angles 11" in the horizontal direction to allow clearance of eaves or roof overhangs. Constructed from powder-coated steel and includes a galvanized aluminum mast, this mount is strong, durable, and stable. WEATHERMOUNT is easy to install and comes with all necessary hardware.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents