Minka Lavery 72723-143C Installation guide

72723-143C
Brand
Minka Lavery
Model
72723-143C
Type
Installation guide

This manual is also suitable for

Minka Lavery 72723-143C is a versatile and stylish lighting fixture designed to enhance your indoor living spaces. With its classic design and durable construction, this fixture is perfect for adding a touch of elegance to any room. It features a sturdy mounting plate for secure installation, and the ability to accommodate a variety of bulbs, including incandescent, CFL, or LED, with a maximum wattage of 60. The fixture comes with clear glass shades that allow for ample light distribution, creating a warm and inviting ambiance.

Minka Lavery 72723-143C is a versatile and stylish lighting fixture designed to enhance your indoor living spaces. With its classic design and durable construction, this fixture is perfect for adding a touch of elegance to any room. It features a sturdy mounting plate for secure installation, and the ability to accommodate a variety of bulbs, including incandescent, CFL, or LED, with a maximum wattage of 60. The fixture comes with clear glass shades that allow for ample light distribution, creating a warm and inviting ambiance.

Candle Cover# CCV20048P-143 for 72722
Candle Cover# CCV20090P-143 for 72723
INSTALLATION INSTRUCTIONS
Model # 72722/72723-143C
READ AND SAVE THESE INSTRUCTIONS
W
A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
-
PREPARING FOR INSTALLATION
(Fig.
1
)
1. Shut off power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Unscrew the cap nuts (H) and the rubber washers (G),
and separate the mounting plate (C) (part #:A-022) from
back plate (F)
4. Then attach the mounting plate (C) to the outlet box (A)
with the outlet box screws (D) (size:8-32*1/2L).
Note: The side of mounting plate marked “GND” must
face out.
CONNECTION THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in Fig.2. making
sure that all wire connectors (B) are secured. If your
outlet box has a ground wire (green or bare copper),
connect the fixture’s ground wire to it. Otherwise,
connect the fixture’s ground wire directly to the
mounting plate using the green screw provided. Tuck
the wire connectors neatly into the outlet box.
FINISHING THE INSTALLATION (Fig.1)
6. Align back plate (F) onto mounting plate (C) and secure
with the rubber washers (G) and cap nuts (H).
7. Insert the glass (K) into the fixture frame (I) and press
the clips (J) tightly to secure glass.
8.
Install type B bulb up to 60 watts or CFL or LED
equivalent (not included) in accordance with the
fixture specification. —DO NOT EXCEED THE
MAXIMUM WATTAGE RATING! (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
9. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone sealant to outline
the outside of fixture back plate (F) where it meets the
wall leaving a space at bottom to allow moisture a
means to escape. (Fig .3)
Your installation is now complete. Return power to the outlet
box and test the fixture.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND
INSTALLATION.
Fig 3
Caulking
Backplate
Fig.2
Fig.
1
Part# A-022
Mounting Plate
1
Mounting screw (2)
Grounding screw (1)
  • Page 1 1

Minka Lavery 72723-143C Installation guide

72723-143C
Brand
Minka Lavery
Model
72723-143C
Type
Installation guide
This manual is also suitable for

Minka Lavery 72723-143C is a versatile and stylish lighting fixture designed to enhance your indoor living spaces. With its classic design and durable construction, this fixture is perfect for adding a touch of elegance to any room. It features a sturdy mounting plate for secure installation, and the ability to accommodate a variety of bulbs, including incandescent, CFL, or LED, with a maximum wattage of 60. The fixture comes with clear glass shades that allow for ample light distribution, creating a warm and inviting ambiance.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents