of the cabinet supporting the appliance must be
heat resistant (or covered with a heat-resistant
material).
For greater stability, attach the oven to the cabinet
with 2 screws through the holes provided on the
side panels.
1.3 ELECTRICAL CONNECTION
Warning:
Installation should only be performed by
installers and qualified technicians.
The appliance must be recess-fitted correctly to
ensure electrical safety. The electrical connections
should be made before the appliance is installed in
its housing.
Ensure that:
- the electrical installation has sufficient voltage (16
Amps),
If the electrical installation in your home requires
any changes in order to connect your appliance,
contact a professional electrician.
During maintenance operations, the appliance must
be unplugged from the electrical grid; fuses must
be switched off or removed.
Warning:
The safety wire (green-yellow) is
connected to the appliance’s terminal and
must be connected to the installation’s earth.
If the oven malfunctions in any way, unplug
the appliance or remove the fuse
corresponding to the sector where the oven
is hooked up.
Warning:
We cannot accept liability for any
accident or incident resulting from non-
existent, defective or incorrect grounding.
Warning:
If the electrical installation in your home
requires any changes in order to connect your
appliance, contact a professional electrician.
If the oven malfunctions in any way, unplug
the appliance or remove the fuse
corresponding to the sector where the oven
is hooked up.
3.1 SETTING THE CLOCK
When switching on the display flashes at 12:00.
Set the clock with + or -.
Confirm with
.
If there is a power cut, the clock flashes.
3.2 CHANGING THE CLOCK
The function selector switch must be in the 0
position.
Press the symbol appears press again.
Adjust the clock setting with + or - .
Confirm with
.
The cooking end time is automatically saved after a
few seconds.
3.3 TIMER
This function can only be used when the oven
is off.
Press ; the symbol appears
.
The minute minder flashes .
Set the minute minder with + and -.
Press to confirm. The timer will then start.
Once the time has lapsed, there is a sound signal. To
stop it, press any key.
The time appears again in the display.
NB: NB: You can modify or cancel the timer at any
time. To cancel, return to the timer’s menu and set to
00:00. If you do not confirm, it will be saved
automatically after a few seconds.
3.4 KEYPAD LOCKING
Press + and - at the same time until the symbol
appears on the screen. To unlock, press + and -
until the symbol disappears off the screen.
• Stopping the turntable
If you think that the size of your dish is preventing
it from turning correctly, programme the
turntable’s stop function during cooking.
Press the and - keys at the same time to stop
the turntable rotating. The turntable’s stopping is
confirmed by a beep.
To restart it, press the and - keys at the same
time.
Setting the clock
3
ENGLISH