Wireless Range Extender
Plug in your wi extender
Normal:
Plug in the power and wait for
1minute, The “WIFI” and “Power”
indicators turn green.
PC setup step
1
Abnormal:
Please press the "Reset" button on
the side of the product for more
than 8 seconds, or contact seller.
Connect your extender SSID
2
Please connect to the SIDD of
“wi-XXXX” .
Note:
You can not Surf on the Internet untill
you nish all the setting steps.
“XXXX” is the last 4 digits letters of
MAC Address which appears at the
back of each product.
Sign in to management page
(e.g.Internet Explorer/Edge/Chrome/Firefox/Safari)
3
Note:
Please make sure that you have
connected the SSID (wi-XXXX)
of the wi extender successfully,
most of the PC / smart will
recognize and Sign in to the
management page
automatically.
If not, please enter
192.168.188.1 on the new
browser.
Enter the default password: admin
4
Scan and select your host router SSID
5
Enter the password of your host router
6
Note:
Please make sure of the right
password (special characters not
allowed, like”%” )
Set your Extender SSID and passord
7
Check datails and make a note of the
Wireless info
8
When you nished setting, please wait
30-40s until extender light is on
9
The light light up, that means
the Exterder Mode successfully.
Note:
Reconnect your extender wi
Dierent Channels working
together would interfere
signal, and the network
speed will get slow. please
change the main router
channel in time.
10
10
10
11
Note:
After check, click “Start
Connect” and wait
30-60 seconds.
admin
csg12321
Connect
Connect
V1.0
After the setting is completed, please observe the signal indicator.
If it lights up, it means that the relay is successful. Please connect
Micael-pro to the Internet! otherwise reconnect.
Please wait 36 seconds
