17
EN
Putting in place
It is not recommended to install your dryer
on a carpeted floor. If this cannot be
avoided, provide proper air circulation
underneath the appliance.
LEVELLING (FIG. 5)
The tumble dryer has to be in a
horizontal position, not sloping.
Levelling is essential to ensure proper
operation of the machine.
Adjust the feet using a spanner to ensure
that the dryer is level and check with a
spirit level (maximum angle 1.5°, that is
less than 1 cm).
ENVIRONMENT
Your tumble dryer releases hot air.
If it is placed near another appliance or
next to a cabinet, a minimum 1 cm space
should be provided in between to assist
ventilation.
ELECTRICAL CONNECTION (Fig. 6)
The electrical installation must be made in
accordance to the standard.
Do not connect the appliance through an
extension but plug it directly into an
electrical socket.
In case of supply cord defect call for a
skilled person to replace it because
special tools are required.
Replacing the electric lead
WARNING: In the interests of safety,
the electrical supply lead should ONLY
be replaced by the manufacturer’s
after-sales staff or a similarly qualified
person.
We cannot be held liable for any
damage and possible repercussions
resulting from a faulty earthing, or the
absence of earthing of the appliance.
DOOR OPENING
Lift the cover to reach the drum.
Cover safety device : It is only possible
to switch on if the cover is properly
closed.
LAUNDRY LOADING
After your clothes have been washed and
spun, put the laundry loosely in the drum
without folding and squeezing.
Any items which have been treated
with a chemical stain remover or an
aerosol, must not be put into the
tumble dryer : inflammable products,
danger of explosion
If your laundry needs such treatment,
it must
absolutely
be done before
washing.
LINT FILTER CLEANING (fig. 7)
WARNING : After every drying process it
is necessery to clear the lint deposits on
the filter.
Do not clean it with water.
The lint filter, on the lefthand side of the
drum, has to be cleaned without any
water after every cycle. Never rinse it
with water at the end of the programme.
➀ Remove the filter by pulling it upwards
➁ Once the thin layer of lint has been
removed from the filter, put it back into
position by pushing it firmly downwards.
At the end of the programme, your
appliance stops at the position “STOP”.
The lamp ‘’filter cleaning’’ lights up to
remind you that you have to clean the filter.
The lamp ‘’on’’ goes out.
Using
Your machine conforms to European
Directives EC/73/23 (Low Voltage
directive) and EEC/89/336
(Electromagnetic Compatibility) as
modified by EEC/93/68.