Installation
This instruction sheet accompanies an optional, transparent protective display
cover for the 600 Series Computer.
Thoroughly clean display before proceeding.
(1) Remove the backing membranes A and C (below) from both sides of the
protective cover
B.
(2) Align and install as shown below. Bow or buckle the protector and wedge the
edges under the bezel on all four sides.
Align cut corner
HERE
A
C
B
Step 1
Step 2
Hints:
Smooth side of protector must be closest to the display.
This leaves the dull hardcoat on the outside to minimize glare and reflections.
Do NOT use tools to remove a worn protector.
Push, pull, slide, buckle or wrinkle a worn protector to remove it.
Display and protective cover must be kept clean.
Dust, dirt, or a foreign object on either can result in false detection of a pen-down event.
