Atomic FASTWALL Installation guide

Atomic
Brand
Atomic
Model
FASTWALL
Type
Installation guide
Questions about ATOMIC products? Give us a ring! 717-626-4408
www.atomicdesign.tv
STEP ONE
Slide two FASTwall panels together to create
one unit.
STEP TWO
Align desired width of bases in a row, with white
feet facing the ground. Be sure that the handle
holes are all aligned to the back of the FASTwall.
When aligning bases, place one more base that the
width of the FASTwall.
i.e. 5 units wide = 6 bases,
7 units wide = 8 bases, etc.
STEP THREE
Insert C3 connectors into middle holes as
illlustrated. Connect FASTwall bases using
F2 connectors.
NOTE: If building FASTwall Columns, connect FASTwall panels using F2 connectors as shown.
Page 1 of 3
Page 1 of 3
RENTAL
SOLUTIONS
FASTWALL
INSTALLATION INSTRUCTIONS
Questions about ATOMIC products? Give us a ring! 717-626-4408
www.atomicdesign.tv
Page 2 of 3
RENTAL
SOLUTIONS
FASTWALL
INSTALLATION INSTRUCTIONS
STEP FOUR
Connect risers to bases using C3 connectors, and C2 connectors on each end.
NOTE: Connecting C4 connectors to each riser as it is placed makes the following steps easier.
If adding interior lighting to FASTwall, place lights inside risers at this point.
STEP FIVE
Use C4 connector and F2 connector on each end to continue assembling FASTwall.
Page 2 of 3
Questions about ATOMIC products? Give us a ring! 717-626-4408
www.atomicdesign.tv
Page 3 of 3
RENTAL
SOLUTIONS
FASTWALL
INSTALLATION INSTRUCTIONS
STEP SIX
Continue building FASTwall one
row at a time. Finish top row with
C2 connectors.
DISASSEMBLY
INSTRUCTIONS:
FASTwall MUST be
disassembled from top
down, in reverse order
as the assembly process.
Removal of bottom
panels first may result in
a toppling wall.
Page 3 of 3
  • Page 1 1
  • Page 2 2
  • Page 3 3

Atomic FASTWALL Installation guide

Atomic
Brand
Atomic
Model
FASTWALL
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents