Page 7
You may need to adjust the door by tightening
or loosening the two screw on the hinge in order
to achieve uniform clearance around the door.
Figure 7
Use screws (L) to connect left door (12) and right
door (13) to left side panel (8) and right side
panel (9).
Tighten screws (L) with phillips screwdriver.
Insert shelf holders (J) into desired holes on
middle panels (4), (5) and, side panels (8) and (9)
then place middle adjustable shelves (11) onto
the shelf holders (J).
Figure 8
Insert nuts (H) into holes on drawer face panel
(16). Attach drawer side panels (17) and (18) to
drawer face panel (16) with bolts (I).
Tighten bolts (I) with phillips screwdriver.
Insert drawer bottom panel (20) into inner
grooves of drawer side panels (17), (18) and
drawer face panel (16).
Insert nut (H) into holes on drawer back panel
(19). Then, attach drawer back panel (19) to the
back side drawer side panels (17) and (18).
Tighten bolts (I) with phillips screwdriver.
Use bolt (N) to connect knob (M) to
drawer face panel (16).
Tighten bolt (N) with phillips screwdriver.
“Lyndon” TV/Media Stand
Assembly Instructions
(8)
(9)
(12)
(13)
(4)
(5)
(11)
(11)
I
I
I
I
I
H
I
I
I
H
H
H
(20)
(19)
(18)
(17)
(16)
Screw to adjust the door.