1-3
Power Lumbar Control
You can increase or
decrease lumbar support
in an area of the
lower seatback.
To increase support, press
and hold the front of the
control. To decrease
support, press and hold
the rear of the control.
Let go of the control when the lower seatback reaches
the desired level of support.
You can also reshape the side wing area of the lower
seatback for more lateral support.
To increase support, press and hold the top of the
control. To decrease support, press and hold the bottom
of the control. Let go of the control when the lower
seatback reaches the desired level of support.
Memory Seat
The controls for the
memory seat are located on
the driver’s door trim panel.
The memory function can recall preset positions for the
driver’s seat cushion and the recliner. The memory function
does not store the lumbar or back support positions.
To set your memory seat do the following:
1. Adjust the driver’s seat to the desired position.
2. Press the SET button and then press the “1” or “2”
button of the memory control within five seconds.
When your vehicle is in PARK (P), press the same
button of the memory control to recall the seat setting.
To do the same thing for a second driver, follow the
preceding steps, but press the other number button of
the memory control. The memory feature only works
when the transmission is in PARK (P).