Copyright © All rights reserved. P-MU-DL-370 Published: 2015.12.02
Remove the security screws
using the enclosed tool.
Remove the head covers. Position the two end caps where
you plan to mount them and mark
the holes on the door and frame.
Drill holes in the marked positions,
and secure the two ends by using
4x25 screws.
Screw hole diameter: 3.3mm
Outlet hole diameter: 12mm
Mount the head covers and tighten
the screws.
41mm
30mm
56mm
38mm
15mm
Screw hole
Outlet hole
Connect the wire to each end of the
loop and test the unit.
Inside diameter: 9mm
DL-370
Copyright © All rights reserved. P-MU-DL-370 Published: 2015.12.02
Remove the security screws
using the enclosed tool.
Remove the head covers. Position the two end caps where
you plan to mount them and mark
the holes on the door and frame.
Drill holes in the marked positions,
and secure the two ends by using
4x25 screws.
Screw hole diameter: 3.3mm
Outlet hole diameter: 12mm
Mount the head covers and tighten
the screws.
41mm
30mm
56mm
38mm
15mm
Screw hole
Outlet hole
Connect the wire to each end of the
loop and test the unit.
Inside diameter: 9mm
DL-370
-
1
Gianni Industries DL-370 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
IRWIN 10507681 Datasheet
-
Austin Taylor 9CAB000504 User manual
-
IRWIN 10504139 User manual
-
Kyosho SUPER TEN FW-04 SERIES User manual
-
-
E-flite P-51B Mustang 32e ARF Assembly Manual
-
-
Carf-Models Composite-ARF Extra 300L Owner's manual
-
NordicTrack NTSY59210 User manual
-
Carf-Models T-27 Tucano 1:4 Owner's manual
