Sytech SYDC127P Owner's manual

Brand: Sytech

Model: SYDC127P

Category: Coffee making accessories

Type: Owner's manual

SY·DC127P

DRIP COFFEE MAKER

USER

MANUAL

Welcome

Thank you for purchasing the new Drip Coffee Maker with Auto Program function SY-DC127P. In order to

fully benefit from this product, please read these instructions carefully. Store the user manual in a safe

place for future reference.

Important Safeguards

The following safety precautions should always be followed when using domestic electrical products to

reduce the risk of electric shock, personal injury or fire. It is important to keep these instructions for future

reference after you have read and understood them and before attempting to use the product.

This symbol warns you of This symbols warn you of Hot

Dangers to your health and surfaces.

Indicates possible injury risks

This symbol refers

to possible hazards

to the machine or

other objects

When using electrical appliances, basic safety precautions should always be followed to reduce

the risk of fire, electrical shock and/or personal injury.

Danger

o Never immerse the appliance in water or any other liquid.

Warning

o Before inserting the mains plug into the socket, check that the mains supply voltage and current

rating corresponds with the power supply details shown on the model label of the appliance.

o The product should only be placed on horizontal flat surfaces, please do not place the product on

inclined or unstable surfaces in order to prevent any injuries.

o During usage, always keep the unit away from the reach of children in order to avoid injury as the

coffee maker operates at high temperatures.

o After use, some parts of the coffee maker will be extremely hot. Use the designated handles and

knobs in order to prevent burning.

o This product should only be used to make coffee with water. Please do not insert any other liquid

such as milk.

o Do not insert the mains plug into the socket if the appliance has no water.

o When using the appliance, always pay attention to the water level marking on the interior of the

coffee maker. Do not operate the appliance below the minimum level and never exceed the

maximum level.

o It is advised to decalcify the appliance at least once a month. Any regular de-scaling agent may be

used, provided that the relevant instructions are observed. Turn on the appliance to clean up the

scale and run the maximum quantity of water through the machine twice without adding coffee.

o This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been given

supervision or instructions concerning use of the appliance by a person responsible for their safety.

o Do not attempt to remove any parts of the housing nor insert any metal objects into the interior of

the appliance.

o To prevent damage to the power cord, always keep it away from sharp edges or corners.

o Do not place the power cord over or near hot surfaces.

o If the supply cord is damaged, contact Sytech Service Centre.

o DO NOT operate the appliance if:

 The appliance or the power cord are damaged

 The appliance has been dropped.

 The crystal jug is broken or shows any signs of cracks.

o Always remove the plug from the wall socket:

 After use

 In case of any malfunction

 Before cleaning

Parts of the SY-DC127P

Control Panel

CLEAN: Cleaning of the filter

STRONG: Intense coffee selector button

PROGRAM: Program mode

HOUR: Hours adjustment

MIN: Minutes adjustment

ON/OFF: On / Off button

Before First Use

Check that all the accessories are complete and the unit is not damaged. Add some water into water tank

up to the max level and brew water for several times without coffee powder. Once this is finalised, empty

the remaining water and clean all the detachable parts thoroughly with warm water.

Using your Coffee Maker

Normal/Manual Function

1. Place the coffeemaker on a hard, flat surface. With the coffeemaker turned off, plug in.

2. Fill the carafe with fresh, cold water (preferably bottled or filtered water). Open the Top cover and pour

the water into the water tank. The number of cups is shown by the water level indicator. Do not exceed

the maximum fill level. Also it is not recommended to make less than 4 cups.

3. Place the carafe with the lid closed in the coffee maker making sure it is well placed into the coffee

maker in order to activate the pause and serve mechanism.

CAUTION: To avoid overflow, the carafe must fit securely into the coffee maker with the lid on. If

it is not properly positioned on the warming plate, hot water or coffee could overflow creating

the risk of burns and injuries.

4. With the Top Lid in the full opened position, insert the filter into the filter basket holder, folding the

seamed edges to ensure a perfect fit into the basket.

5. Add the coffee using the measuring scoop provided. Brew coffee with the coffee water ratio you

normally use when you prepare ground coffee regularly. If you prefer strong coffee, we recommend the

following European method, which produces a rich, full-bodied flavor. Use 1 level scoop for each cup (6

fluid ounces) or 10 level scoops for a full pot of coffee. Experiment with the amount of coffee used in

order to adjust the flavor to your taste.

6. Close the Top Lid and make sure it is securely closed.

7. With the Top Lid firmly closed and the carafe securely in place, press the ON button. The red color LED

light will light up and flash to indicate that the brewing cycle has started. Once the process has ended,

the red LED light will be on constantly indication that the “keep warm” function has begun. The keep

warm function works for 40 minutes before the unit fully shuts down.

8. If you wish to interrupt the brewing process in between, simply press the OFF button at any given time.

9. When the brewing process ends and the water level indicator is empty, there will still be hot liquid in the

filter basket. Wait a few minutes for the rest of the liquid to drip through into the carafe.

10. After the coffee grounds have cooled, open the Top Lid and carefully remove the filter by grasping the

handle and lifting straight up from the Funnel compartment. Discard used coffee filter and grounds.

CAUTION: Coffeemaker becomes very hot during the brewing cycle. Please handle with extreme

care.

11. The “keep warm” plate will operate as long as the switch is on.

12. Always switch the coffee maker to OFF when the carafe is empty or when you no longer want to keep

the coffee hot. The coffee maker will shut off automatically after 40 minutes.

CAUTION: Never open the

Top

Lid

during the brewing cycle; even if no water is drainin

g from

the Funnel. Extremely hot water/coffee can spill out from the basket and cause injury. If

water/coffee is not draining from the filter basket, IMMEDIATELY unplug the unit and wait 10

minutes before opening and checking the filter.

13. If two (2) or more pots of coffee are to be made it is recommended that the coffee maker is allowed to

cool for 10 minutes between each brewed pot. The filter should also be rinsed out after each brewing

cycle.

Auto-Brewing Function

1. Before commencing the brewing process, press the HOUR and then the MIN buttons to set the current

time. Press and hold the buttons to scroll through numbers quickly. When the number displayed

approaches the desired setting, release the button to advance one digit at a time and fix the correct

time.

2. To set the desired ‘auto brew’ start time, first press the PROGRAM button. Next set the time you want

the coffee to begin brewing by using the HOUR and MIN buttons following the same directions for

setting the clock.

3. After you have successfully set the program, the machine will be set into auto-brew mode. A green LED

light will flash and the word “AUTO" will show up on the LCD screen.

4. Your coffee maker will automatically begin brewing at the pre-set time. When the brewing cycle begins,

the red light will flash to indicate the coffee maker is in operation.

5. Press the PROGRAM button for about 3 seconds to cancel the auto-brewing mode.

Intense Coffee Function

This function is to lengthen the brewing time to make sure coffee has been completely extracted.

A: Press the “STRONG” button on the unit for it to start working immediately.

B: When making coffee using the normal/manual function, you may press the “STRONG” button at any

time to shift to this function instantly.

Pause & Serve Function

This function allows you to interrupt the brewing cycle at any time and pour a cup of coffee before the

entire carafe is finished brewing and before the whole process has completed.

Make sure the carafe is positioned firmly against the back of the coffee maker when placed back in order

to resume the brewing process.

NOTE: While the pause and serve is a convenient way to pour a cup of coffee mid-cycle, we recommend

you wait until the completion of the brewing cycle as the strength of coffee poured mid-cycle may vary from

the finished brew, and this may affect the finished brew’s strength and flavor.

CAUTION: You may take out the carafe, pour and serve at any time. The appliance will stop

dripping automatically. However, you should not exceed 30 seconds, as this will resume

automatically.

Hints for Great-Tasting Coffee

1. Always use fresh and cold water.

2. For stronger or milder coffee, increase or decrease the amount of coffee grounds to suit your taste.

3. Finer coffee grinds, such as Drip and Automatic Drip Coffeemaker (ADC) coffee grounds, promote a

full extraction of flavor and a rich, full-bodied coffee.

4. Store unused coffee grounds in a cool, dry place. After opening a package of coffee grounds, tightly

reseal it and store it in the refrigerator to maintain freshness.

5. For optimum coffee taste, buy whole coffee beans and finely grind them just before brewing.

6. Do not reuse coffee grounds; this greatly reduces the coffee's flavor.

7. Reheating coffee is not recommended as coffee is at its peak flavor immediately after brewing.

8. A clean Coffeemaker is essential for making great-tasting coffee. Clean regularly as specified in the

"Care and Maintenance" section.

9. Prevent an oily build-up: A small amount of oil on the surface of brewed coffee is due to the release of

oil from roasted coffee beans. Heavily-roasted coffee beans release more oil than others. Regularly

cleaning your Coffeemaker will prevent an oily buildup.

Care and Maintenance

WARNING:

Always unplug the Power Cord from the electrical outlet and allow the product to cool

completely before cleaning or storing.

Cleaning:

• The Filter Basket may be placed on the upper rack of a dishwasher for cleaning or hand washed in

warm, soapy water. The Reusable Mesh Filter must be washed by hand.

NOTE: When washed in a dishwasher, the parts may appear to fade. Restore this by carefully

polishing them with a soft, dry cloth.

• Wipe the exterior surface of the Coffeemaker with a soft, damp cloth. Do not use metal scouring

pads or abrasive cleaners.

Removing Mineral Deposits:

To keep your Coffeemaker operating efficiently, remove mineral deposits left by water. At least

once a month or after 60 uses of the coffee machine a green LED will flash on the screen indicating

that the coffee machine needs to be cleaned. Use a water and vinegar household cleaning solution

as described below to prevent the build-up of mineral deposits (using water and vinegar solution is

an optional method, you may use only water). If the water in your area is especially high in

minerals, do this more often.

1. Fill the jug with one part of white vinegar and three parts of cold water.

2. Pour the water and vinegar mixture into the Water Reservoir.

3. Place the jug (Lid off) onto the Base.

4. Press the CLEAN Button; the red Indicator Light will begin to flash. NOTE: During cleaning, more

steam occurs than when brewing coffee.

5. When the water-vinegar solution stops dripping into the jug, please note that the cleaning process has

not yet finished, please patiently wait as this process recommences after a few minutes.

6. Discard the cleaning solution from the jug once the process has completed or the water reservoir is

empty.

7. Allow the Coffeemaker to cool for three minutes, then remove, rinse, and replace the Filter Basket. You

may opt to repeat the cycle of cleaning once again if you feel this is necessary.

8. Rinse the Coffeemaker by brewing a Glass of cold water.

9. Allow the Coffeemaker to completely cool and clean it by washing the jug, the Filter Basket, and the

Reusable Mesh Filter in soapy water; rinse and let dry.

Specifications & Features

• Drip coffee maker

• Prepare up to 10-15 cups (1.8 liters)

• 24 hours program selector

• Intense coffee aroma setting function

• Glass jar

• Non-stick coating heating plate

• Intelligent drip system

• Anti-drip and auto off function

• Removable filter for easy cleaning

• Electronic On/Off button

• Overheat protection by thermostat and

thermos fuse

• Removable parts for easy cleaning

• Power: 950W

• Voltage: 220-240V ~ 50/60Hz

Declaration of Conformity

Manufacturer Name: Satyatrade S. L.

Address: Pol. Ind. La Raya. C/ Guadalquivir, 2.

Camarma de Esteruelas, 28816 Madrid

Tel: 902 430 967

Fax: 91 8864285

NIF: B83254763

Manufacturing country: China

Description: Drip Coffee Maker

Sytech® SY-DC127P complies with the following directives:

EMC Standard: Directive 2014/30/EU

LVD Standard: Directive 2014/35/EU

ROHS Standard: Directive 2011/65/EU Restriction of Hazardous Substances

Signed: Ajeet Nebhwani Utamchandani

Sole Administrator

Sytech SYDC127P Owner's manual

Brand: Sytech

Model: SYDC127P

Category: Coffee making accessories

Type: Owner's manual

Download PDF

report

Sytech SYDC127P Owner's manual

Sytech SYDC127P Owner's manual

Related papers

Other documents