2.5-inch 100GB SATA Hard Disk Drive
PC-HDD100GS-2 User’s Guide
CONTEC CO., LTD.
Thank you for purchasing the CONTEC PC-HDD100GS-2.
Please use this product in accordance with the procedures described in this document. This product can be used for the
CONTEC’s following models. (Don’t use this product with any other devices.)
- PC-HDD100GS-2
BOX Computer: BX-1000xx-ACxxxxx, BX-961D-DCxxxx
Package Contents
- Hard Disk Drive [PC-HDD100GS-2] …1 - Warranty Certificate …1
- User’s Guide (this sheet) …1 - Serial number label …1
Disposal
When disposing of the product, follow the disposal procedures stipulated under the relevant laws and municipal
ordinances.
Safety Information
This document provides safety information using the following symbols to prevent accidents resulting in injury or death
and the destruction of equipment and resources. Understand the meanings of these labels to operate the equipment safely.
DANGER indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury or in
property damage.
Disclaimers
We shall not be liable for any consequential damages such as losses and lost profits resulting from the operation of this
product. For any reason we shall provide no warranty for the stored contents on your hard disk.
Handling Precautions
- Do not apply pressing force on the top of cover.
- Do not cover the breathing hole on the top cover.
- The system is responsible for providing sufficient air movement to maintain surface temperatures below 90°C on the
top cover
- Do not touch the interface connector pins and the surface of printed circuit board.
- Hard disk is precision instruments. Be extremely careful in handling during and after assembly.
- Hard disk can malfunction when it is subjected to electrostatic discharge (ESD) or physical shock. Handle with care so
that antistatic measures are taken in advance and do avoid shock.
- Do not cover BREATING HOLE. Doing so may lead to malfunctions.
- Be sure to turn off the power of the unit when plugging in or unplugging interface connectors.
- CONTEC bears absolutely no responsibility for use if modified hard disk.
- Excessive vibration or impact greater than its specification, if this hard disk is subjected to, might cause a fatal error that
is not recoverable.
- Service life of the drive is 3,000 power on hours, whichever comes first.
These are the standard values when the environmental and operational conditions specified in page 3 are observed and
are not the guaranteed values.
Specification
Serial-ATA Revision 2.6 (3.0Gbps)
Transfer
velocity
Consumed
power
2.0W / 2.0W / 2.3W (typ.)
5.5W (Max.) (-30 to -20°C)
Operating
5 - 90%RH (With no condensation)
Temperature
change gradient
60°C/h or less for down
(With no condensation from temperature gradient)
1049.8hPa - 494.9hPa (Above the sea -300 - 5,650m)
Swept sine
vibration
2.5G or less (50 - 200Hz)
2.0G or less (200 - 500Hz)
Shock
300G or less (2ms)
100G or less (11ms)
Non-
operating
5 - 95%RH (With no condensation)
Temperature
change gradient
60°C / h or less for down
(With no condensation from temperature gradient
1049.8hPa - 193.3hPa (Above the sea -300 - 12,000m)
5.0G or less (10 - 500Hz)
3,000 hours (-30 to 85°C)
69.85 (W) x 100.0 (D) x 9.5 (H)
*1 Maximum power consumption at motor startup
Fixed disk characteristics
*2 Physical sector 4096 bytes. Supports 512 emulation.
Physical Dimensions
Copyright 2014 CONTEC CO., LTD. All Rights Reserved.
LTD.
-9-31, Himesato, Nishiyodogawa-ku, Osaka 555-0025, Japan
Japanese http://www.contec.co.jp/ English http://www.contec.com/
Chinese
http://www.contec.com.cn/
No part of this document may be copied or reproduced in any form by any means without prior written consent of CONTEC CO., LTD.