DURA-LIFT DLSR9 Operating instructions

DLSR9
Brand
DURA-LIFT
Model
DLSR9
Type
Operating instructions

This manual is also suitable for

1) Unplug your garage door opener and disconnect it
from the garage door.
2) Secure the garage door in the full open position by
placing a C-clamp or vice grip above the top roller to
keep the door from moving (Figure 1).
3) Remove the old seal and clean the track for easy
installation of the new seal.
4) Insert the full new seal in one end. Once it is fed all
the way through, crimp the retainer down on the seal
(Figure 2).
5) On the other end, push 1 inch extra into the track and
crimp that retainer.
6) Trim the end ush with the door edge.
7) Remove the clamps, close the door and reconnect it
to the door opener.
TOOLS NEEDED
C-Clamp and Vice Grips
Figure 1
Figure 2
INSTALLATION INSTRUCTIONS
WARNING!
INSTALLATION BY A TRAINED DOOR SYSTEMS TECHNICIAN IS HIGLY RECOMMENDED TO
PREVENT SERIOUS INJURY OR DEATH.
Springs bottom brackets, red colored fasteners, cables, and supports are under extreme tension and can cause serious injury or
death. You should never remove the bottom roller carrier. If your garage door is connected to an automatic opener, be sure to
disengage the opener before starting installation. Do not place ngers or hands into door section joint. Use lift handles or
gripping points when operating door manually. Never use other objects to prop open the door. If complications during installa-
tion occur, contact a trained door systems technician for service.
Weather Seal
C-clamp
FOAM Rubber Bottom WEATHER
Seal For WOOD Garage Doors
T-END RUBBER BOTTOM
SEAL INSTRUCTIONS
DURALIFTHARDWARE.COM
  • Page 1 1

DURA-LIFT DLSR9 Operating instructions

DLSR9
Brand
DURA-LIFT
Model
DLSR9
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents