GROHE 32 298 Installation guide

D

.....1

NL

.....6

PL

.....11

P

.....16

BG

.....21

CN

.....26

GB

.....2

S

.....7

UAE

.....12

TR

.....17

EST

.....22

UA

.....27

F

.....3

DK

.....8

GR

.....13

SK

.....18

LV

.....23

RUS

.....28

E

.....4

N

.....9

CZ

.....14

SLO

.....19

LT

.....24

I

.....5

FIN

...10

H

.....15

HR

.....20

RO

.....25

DESIGN + ENGINEERING

GROHE GERMANY

www.grohe.com

32 298

Ladylux 3 Café

99.0034.031/ÄM 231687/06.14

D

.....1

NL

.....2

PL

.....4

P

.....6

BG

.....7

CN

.....9

GB

.....1

S

.....3

UAE

.....4

TR

.....6

EST

.....8

UA

.....9

F

.....1

DK

.....3

GR

.....5

SK

.....6

LV

.....8

RUS

...10

E

.....2

N

.....3

CZ

.....5

SLO

.....7

LT

.....8

I

.....2

FIN

.....4

H

.....5

HR

.....7

RO

.....9

English .....1

Français .....2

Español .....3

I

S.v.p remettre cette instruction à l'utilisateur de la robinetterie!

Entregue estas instrucciones al usario final de la grifería!

Please pass these instructions on to the end user of the fitting!

Prod.Nr.

Page is loading ...

1

English

Application

Operation is possible in conjunction with:

• Pressurized storage heaters

Operation is not possible with:

• Low-pressure storage heaters (displacement water heaters)

Specifications

• Max. flow: 6.6 L/min or 1.75 gpm/60 psi

• Flow pressure

- min. 7.25 psi

- recommended 14.5 - 72.5 psi

- greater than 72.5 psi, fit pressure reducing valve

• Max. operating pressure 145 psi

• Test pressure 232 psi

• Temperature

- max. (hot water inlet) 158 °F

- thermal desinfection possible max. 194 °F

• Water connection: cold - RH hot - LH

• Deck thickness max. 2 3/8"

• Non reversible cartridge

Notes:

- Major pressure differences between cold and hot water

supply should be avoided.

- To be installed according to local codes and regulations.

- This faucet is not intended for the use with portable

appliances.

Installation

Flush piping system prior and after installation of faucet

thoroughly!

Prepare sink faucet

Refer to the dimensional drawing on fold-out page I.

Mount sink faucet, see fold-out page III, Fig. [1].

1.Fit O-Ring (A).

2.Insert faucet into sink. Feed the connection hoses

separately through the sink.

3.Fit brace (B), if necessary, with washer (C) and connect

nut (D) with tube (E). To do this, insert fitting key (F) into

tube (E) and turn fitting key (F) clockwise to fasten faucet.

(Tube may also have to be turned with an 22mm open

ended wrench.)

Note:

If brace (B) is omitted, deck thickness can be increased by

9/16" to a total of 2 3/8".

Connect sink faucet, see Figs. [1] and [2].

- Cold water connection (marked blue) = right

- Hot water connection (marked red) = left

Avoid cross connection. The cartridge is not reversible.

Connect spray hose and spray, see Figs. [3] and [4].

1.Feed the spray hose (G) through the spout (H), see Fig. [3].

2.Feed the spray hose (G) through the faucet body from

above and fit spout (H) so that it snaps into place.

3.Connect the spray (I) with guide ring (I1) to the spray

hose (G).

4.With spray inserted slide on spring (J) onto spray hose (G)

from below, see Fig. [4].

5.Install the snap coupling (K) on the end of the spray

hose (G) and tighten by hand.

6.Pull the sleeve (K1) of the snap coupling (K) downwards and

fit to the union (L).

To ensure that the spray (I) is correctly seated when

inserted, lug (G1) on the spout must engage in recess on the

spray (I2), see Fig. [3].

Open cold and hot water supply and check connections

for leakage!

Operation

1. Lever, see fold-out page III, Fig. [5].

2. Spray, see Fig. [6].

Turning off the faucet automatically diverts the water flow from

spray to aerator.

Flow rate limiter

This faucet is fitted out with a flow rate limiter, permitting an

infinitely individual variable reduction of the flow rate. The

highest possible flow rate is set by the plant before despatch.

The use of flow rate limiters in combination with hydraulic

instantaneous water heaters is not recommended.

To activate see “Replacing the cartridge” point 1 to 3,

Figs. [7] and [8].

Maintenance

Inspect and clean all parts, replace as necessary and grease

with special grease.

Shut off cold and hot water supply!

I. Replacing the cartridge, see fold-out page III, Fig. [7].

1.Remove fixing screw (M) using a 3mm allen wrench.

2.Pull off lever (N).

3.Turn cap (O) through 180° (slot pointing upwards) and pull

off the cap.

4.Remove fixing screw (P) and pull off adjusting lever (R).

5.Remove screws (S) and detach complete cartridge (T).

6.Change the complete cartridge (T).

Assemble in reverse order.

Observe the correct installation position!

Make sure that the cartridge seals engage in the grooves

on the housing. Fit screws (S) and tighten evenly and

alternately.

II. Check valve, see fold-out page III, Fig. [9].

- Unscrew spray (I) and remove filter (U) and check valve (V).

III. Strainer and rose, see fold-out page III, Fig. [9].

1.Pull out ring (W) and unscrew rose (X) by using wrench (Y).

2.Clean strainer (Z) and rose (X).

Thanks to the SpeedClean nozzles, which must be regularly

cleaned, limescale deposits on the rose can be removed by

simply rubbing with the fingers.

The function of the SpeedClean nozzles is guaranteed for a

period of five years.

Assemble in reverse order.

Replacement parts, see fold-out page II ( * = special

accessories).

Care

Instructions for care of this faucet will be found in the Limited

Warranty supplement.

Page is loading ...

2014/03/21

www.grohe.com

D

&

+49 571 3989 333

[email protected]

A

&

+43 1 68060

[email protected]

AUS

Argent Sydney

&

+(02) 8394 5800

Argent Melbourne

&

+(03) 9682 1231

B

&

+32 16 230660

[email protected]

BG

&

+359 2 9719959

grohe-bulgaria@grohe.com

CAU

&

+99 412 497 09 74

info-az@grohe.com

CDN

&

+1 888 6447643

[email protected]

CH

&

+41 448777300

[email protected]

CN

&

+86 21 63758878

CY

&

+357 22 465200

[email protected]

CZ

&

+420 277 004 190

grohe-cz@grohe.com

DK

&

+45 44 656800

grohe@grohe.dk

E

&

+34 93 3368850

grohe@grohe.es

EST

&

+372 6616354

grohe@grohe.ee

F

&

+33 1 49972900

marketing-fr@grohe.com

FIN

&

+358 10 8201100

teknocalor@teknocalor.fi

GB

&

+44 871 200 3414

info-uk@grohe.com

GR

&

+30 210 2712908

nsapountzis@ath.forthnet.gr

H

&

+36 1 2388045

[email protected]

HK

&

+852 2969 7067

[email protected]

I

&

+39 2 959401

[email protected]

IND

&

+91 124 4933000

customercare.in@grohe.com

IS

&

+354 515 4000

[email protected]

J

&

+81 3 32989730

[email protected]

KZ

&

+7 727 311 07 39

[email protected]

LT

&

+372 6616354

grohe@grohe.ee

LV

&

+372 6616354

grohe@grohe.ee

MAL

&

+1 800 80 6570

info-singapore@grohe.com

N

&

+47 22 072070

grohe@grohe.no

NL

&

+31 79 3680133

vragen-nl@grohe.com

NZ

&

+09/373 4324

P

&

+351 234 529620

[email protected]m

PL

&

+48 22 5432640

biuro@grohe.com.pl

RI

&

+62 21 2358 4751

info-singapore@grohe.com

RO

&

+40 21 2125050

[email protected]

ROK

&

+82 2 559 0790

info-singapore@grohe.com

RP

&

+63 2 8041617

RUS

&

+7 495 9819510

[email protected]

S

&

+46 771 141314

grohe@grohe.se

SGP

&

+65 6 7385585

info-singapore@grohe.com

SK

&

+420 277 004 190

grohe-cz@grohe.com

T

&

+66 2610 3685

info-singapore@grohe.com

TR

&

+90 216 441 23 70

[email protected]

UA

&

+38 44 5375273

[email protected]

USA

&

+1 800 4447643

us-customerservice@grohe.com

VN

&

+84 8 5413 6840

info-singapore@grohe.com

BiH

AL

HR

KS

ME

MK

SLO

SRB

&

+385 1 2911470

[email protected]

Eastern Mediterranean,

Middle East - Africa

Area Sales Office:

&

+357 22 465200

[email protected]

IR

OM

UAE YEM

&

+971 4 3318070

grohedubai@grome.com

Far East Area Sales Office:

&

+65 6311 3600

[email protected]

GROHE 32 298 Installation guide

This manual is also suitable for

GROHE 32 298 Installation guide

in other languages

Related papers

Other documents