2. Bontrager
  3. helmet fit system replacement instruction

Bontrager helmet fit system replacement instruction Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Bontrager helmet fit system replacement instruction Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Helmet Fit System
Replacement Instructions
ENGLISH
Helmet Fit System Replacement Instructions
1
Click below to select your t system.
Quickset II Headmaster II
BOA WaveCel BOA
Velocis MIPS BOA
Copyright 2021 Trek Bicycle Corporation All Rights Reserved
Helmet Fit System Replacement Instructions
2
Quickset II System
Remove the old t system
NOTICE: Detach the t system one piece at a time. Grasp
each piece as close as possible to the attachment point
as shown. Grasping farther from the attachment point
could break the system and make it difcult to remove.
Use one hand to rmly hold the helmet. Use the other
hand to grasp each piece of the t system as close as
possible to where it attaches to the helmet (shown below
in red). Pull it toward the center of the helmet to detach it.
1
2
Install the new t system
WARNING
Proper helmet t
For proper t, the t system must be woven through the
straps as shown below.
2
1
3
Helmet Fit System Replacement Instructions
3
BOA, WaveCel BOA and Headmaster II
Note: The illustrations below may differ slightly from your t system, but the steps are the same.
Remove the old t system
NOTICE: Detach the t system one piece at a time. Grasp
each piece as close as possible to the attachment point
as shown. Grasping farther from the attachment point
could break the system and make it difcult to remove.
Use one hand to rmly hold the helmet. Use the other
hand to grasp each piece of the t system as close as
possible to where it attaches to the helmet (shown below
in red). Pull it toward the center of the helmet to detach it.
1
2
Install the new t system
WARNING
Proper helmet t
For proper t, the t system must be woven through the
straps as shown below.
1
2
3
Helmet Fit System Replacement Instructions
4
Velocis MIPS BOA System
Remove the old t system
NOTICE: Detach the t system one piece at a time. Grasp
each piece as close as possible to the attachment point
as shown. Grasping farther from the attachment point
could break the system and make it difcult to remove.
Use one hand to rmly hold the helmet. Use the other
hand to grasp each piece of the t system as close as
possible to where it attaches to the helmet (shown below
in red). Pull it toward the center of the helmet to detach it.
1
2
Install the new t system
WARNING
Proper helmet t
For proper t, the t system must be woven through the
straps as shown below.
1
2
3
/