HP SATA DVD RW
Optical Drive
Installation Instructions
for HP ProLiant DL servers
Overview
The HP SATA DVD RW optical drive provides a read and write
solution for HP ProLiant DL servers. The SATA DVD RW drive has a
SATA interface and can read and write to CD and DVD media.
More information about this product, as well as the latest drivers and
flash ROM images, are available from the HP website
(http://www.hp.com
).
Although the SATA DVD RW drive reads and writes to audio and
video discs, the primary purpose of the drive is data storage.
Features
The SATA DVD RW drive includes the following features:
• Has SATA interface
• Reads CD and DVD media
• Writes to CD and DVD writeable media
Installing the drive
CAUTION: To prevent damage to electrical components,
properly ground the server before beginning any
installation procedure. Improper grounding can cause
electrostatic discharge.
To install the SATA DVD RW drive:
1. Shut down the operating system as outlined in the operation
system instructions.
2. Power down the server.
3. Power down all peripheral devices.
4. Remove the power cord from the outlet, and then remove it
from the server and all peripheral devices.
5. Remove components that prevent access to the removable-
media drive bays.
6. Position the drive in the drive bay, and then slide the drive into
the server. If needed, secure with the appropriate fasteners.
7. Connect the SATA data cable to the server and to the data
connector on the rear of the drive.
8. Connect the power connector to the server power. If required,
use the supplied power conversion cable.
© Copyright 2007, 2008 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should
be construed as constituting an additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained herein.
Microsoft and Windows are U.S. registered trademarks of Microsoft
Corporation. Bluetooth is a trademark owned by its proprietor and used by
Hewlett-Packard Com
p
an
y
under license.
Part Number 453282-002
April 2008 (Second Edition)
9. Reinstall all components removed from the server during the
installation procedure.
10. Reconnect all peripheral devices to the server.
11. Connect the power cord to the server, and then connect it to a
properly grounded electrical outlet.
12. Power up the server.
For detailed instructions on installing the drive, see the server-specific
user documentation provided with your server.
Software support for writing
DVD media
Writing data to CD and DVD media requires a software solution
compatible with your operating system. The SATA DVD RW drive kit
includes the Roxio Dual Installer for Easy Media Creator/Digital
Media Plus software (EMC/DMP), which is compatible with
Microsoft® Windows® operating systems.
To install Roxio Dual Installer for EMC/DMP:
1. Insert the Roxio CD into the drive.
2. Follow the onscreen instructions to complete the setup.
If the installation window does not appear, complete the following
steps:
1. Select Start>Run.
2. Type d:\setup (where d is the appropriate drive letter).
3. Click OK.
4. Follow the onscreen instructions to complete the setup.
-
1
-
2
HP ProLiant DL170e - G6 Server Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
HP 628691-001+481045-B2 Datasheet
-
-
-
-
HP ProLiant DL160 User manual
-
-
-
-
Hewlett Packard Enterprise 658552-421 Datasheet
-
Other documents
-
HP (Hewlett-Packard) DL160 User manual
-
-
-
-
-
-
-
-
-