Hembry Creek SWUT490BRS Installation guide

Hembry Creek
Brand
Hembry Creek
Model
SWUT490BRS
Type
Installation guide

This manual is also suitable for

SUGGESTED TOOLS AND MATERIALS
Silicon Sealant Tape Measure Safety Glasses
1
SINK INSTALLATION
3
INSTALLATION INSTRUCTIONS
BRAZILIAN SLATE VANITY TOP
2
®
For customer support please visit www.xylem.biz or call 866 395 8112 weekdays 8:00 to 5:00 EST or fax 866 395 8113 any time
All Sizes
1
BEFORE YOU BEGIN
Observe all local plumbing and building codes.
Follow these instructions only if it applies to your installation.
Before installation, carefully inspect it for damage. Return the vanity top to its packaging until you are ready to install it.
These instructions contain important care and cleaning instructions. Please review these instructions carefully.
CAUTION! Risk of product damage. Do not use plumbers putty or oil-based sealers with this
vanity top. These products will stain the surfaces permanently.
Finally, place the bottom side of back splash with sealant
onto the countertop and check alignment of backsplash.
Adjust the leg levelers as needed
** NOTE: Sink style, shape, cutout on top, vanity may vary from the picture above. Instructional purposes only.
Apply bead of quality sealant evenly
along the top of the vanity
Apply silicone sealant evenly along
the bottom of backsplash and wall
CARE AND CLEANING INSTRUCTIONS
BRAZILIAN SLATE VANITY TOP
®
For customer support please visit www.xylem.biz or call 866 395 8112 weekdays 8:00 to 5:00 EST or fax 866 395 8113 any time
All Sizes
2
•
Follow general cleaning requirements that prevent staining and surface dulling.
Wipe up spills immediately with a soft sponge, even if a spill is just water.
Dust the countertop daily. Dust particles left to accumulate rub against the countertop and create microscopic scratches.
Over time, the scratches will build up and lead to a marred, clouded finish.
Wash the slate countertop regularly with a damp sponge and mild, non-acidic, non-antibacterial cleaner.
Maintain the slate countertop's lustrous sheen by routinely polishing it with mineral oil.
To polish, pour a drop of mineral oil onto the countertop's surface. Smear the oil around the countertop, using a soft, cotton
cloth. Buff the oil into the slate, working in circular motions.
Continuously fold over the cloth to expose a dry portion.
Apply mineral oil weekly for the first few months after installation, then once a month thereafter.
Softness commonly characterizes slate, meaning slate countertops are prone to scratching. However, the softness also makes
scratch removal simple.
If an object was dragged across the countertop, leaving a line etched in the slate, buff away the scratch with 120-grit
sandpaper.
Once the scratch is removed, wipe away the sanding particles, then moisten the area and finish-sand with 220-grit wet/dry
sandpaper.
Wipe away the particles again and rub the area with mineral oil to repolish.
Xylem slate countertops are fabricated at the factory with permanence in mind, but finishes in heavy-use areas can gradually
diminish, making the slate susceptible to food and liquid stains.
Polishing with mineral oil on a regular basis goes a long way in protecting a slate countertop
To ensure an adequate seal, reapply an appropriate stone sealer approximately every two years.
You'll know your countertop is past due for resealing when water drops no longer bead on the surface.
RESEALING
POLISHING
CLEANING
SCRATCHES
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
  • Page 1 1
  • Page 2 2

Hembry Creek SWUT490BRS Installation guide

Hembry Creek
Brand
Hembry Creek
Model
SWUT490BRS
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents