Insert the batteries 1. Transmitter
Remove the battery compartment cover.
Fit the 2 x AA batteries, observe the correct polarity.
Replace the battery cover and lock it.
Model
Remove the battery compartment cover.
Fit the 5 x AA batteries, observe the correct polarity.
Close the battery compartment cover and lock it in place.
Note: The round transport locks with which the vehicle was secu-red in the cardboard box can be used to open
and close the locks on the vehicle and transmitter.
Battery warning:
Non-rechargeable batteries are not to be recharged!
Do not open! Do not dispose of in fire! Do not mix old and new batteries!
Do not mix alkaline batteries, standard (carbon-zinc) or rechargeable batteries!
Rechargeable batteries are to be removed from the toy before being charged!
Rechargeable batteries are only to be charged under adult supervision!
The supply terminals are not to be short-circuited!
Binding procedure
After inserting the batteries into the transmitter, the LED on the transmitter will flash and the transmitter is ready to
bind. Now switch on the model. When the LED on the transmitter is no lon-ger lit, the vehicle is bound to the
transmitter. The transmitter does not have an on/off switch and will automatically turn off after approximately 60
seconds of inactivity. Pressing any trans-mitter button will reactivate it. The vehicle has an on/off switch and must
be switched off after use to prevent the batteries from discharging!
Attention!
Let the model cool off sufficiently after each use before putting it back into operation. Let the model cool off
sufficiently after each use before putting it back into operation. When changing batteries there has to be a cooling
phase of at least 10 min before model can be operated again. Overheating can damage the electronics or may
result in fire.
1. Forward/Reverse
If you press the forward or reverse button, the model drives forwards or backwards.
2. Turn left /right