Kogan KAA45BLUBUDS User guide

Type
User guide
A45 TRUE WIRELESS
EARBUDS WITH ENC
KAA45BLUBUDS
User Safety Instructions
To avoid any possible hearing damage, keep the volume at a moderate level.
Avoid listening to music at loud volume levels for prolonged periods of time, as this may
cause permanent hearing damage or hearing loss.
Always be aware of your surroundings while operating and do not use the earphones
while driving, cycling, running or jogging or when doing any activity which requires your
attention and ability to hear.
For best results and increased battery life, disconnect the USB cable after charging is
complete.
The specified range of the charger output is 5V/1A-5V/1.5A. If the output voltage or
current of the charger exceeds the specified range, this will cause serious damage to
the product.
Even if not using, charge the earphones and the battery case at least once every 6
months, for the good life cycle of the product.
Store in cool and dry place. Keep away from hot and humid conditions.
The battery is designed to last lifecycle of the product. It should only be removed by a
recycling facility. And attempt to remove or replace the batteries will damage the
product and void the warranty.
Bluetooth products can be affected by the environment. Do not use it in environments
with large electromagnetic fields / high radiation levels. The Bluetooth signal will be
impacted and less than optimal performance may occur.
When battery power is less than 10%, it will result in insufficient audio output. It is
recommended to only use the headphones when sufficiently charged.
In case of obstacles or multiple 2.4GHz signals in the same frequency band, the
Bluetooth signal will be impacted and less than optimal performance may occur.
Do not place the Bluetooth earphones in water or apply excessive force on it those may
cause damage to the earphones, resulting in poor sound quality.
SAFETY & WARNINGS
Notes:
If you use earphones while watching videos, the sound may be slightly out of sync with
the video.
OVERVIEW
L. earphone
power indicator
Charging
box power
indicator
R. earphone
power indicator
LED display
Place the earphones in the charging box and connect the USB-C cable to the charging
case. The charging box and the earphones will begin charging.
Pairing the Earphones
BEFORE FIRST USE
Notes:
When the earphones are placed in the charging box, lay them flat and make sure they
are in place before closing the cover to avoid poor contact between the headset and
the charging probe, which can lead to charging errors or damage to the earphones.
Kogan A45 Pro
Correct position:
Incorrect positions:
WEARING THE EARBUDS
Button Functions
Click once
(Music) Play/Pause
Double click
(Music) Left ear: Previous song
(Phone) Left ear: Answer call
(Music) Right ear: Next song
(Phone) Right ear: End call
Press and hold 3 seconds: Power on
Press and hold 6 seconds: Power off
Press and hold 2 seconds
(Phone) Reject call
Long press (music)
Left ear: Volume down
Right ear: Volume up
Click three times (with music paused)
Activate smart assistant
OPERATION
Charge the Charging Box
Plug the USB-C charging cable into the USB-C port
in the charging box, the LED display of the charging
box shows the battery level from 1 to 100% until it is
fully charged.
Charging Other Devices Using the Charging Box
The charging box can be used as a power bank
to charge you phone and other devices.
Connect the device to the USB-A port on the
charging box using a USB cable.
During charging, the LED indicator grids
decrease from 100%, indicating the battery
status until the phone is fully charged
Charging Indicators
Charging the earphones: Place the earphones in the charging box, close the cover and
the earphones will automatically start charging. The corresponding (L/R) battery
indicators will be solid red.
When full, the blue indicator will turn off and the blue LED indicator will turn on for 15
seconds and then turns off.
Headphone Status Indicator
Charging
Red indicator on
Fully Charged
Blue indicator on
Pairing
Blue and Red indicator flashing
Pairing successful
Indicators go off
Low Battery
When battery level is low you will hear a warning messageBattery low, please recharge.
The message is repeated after every 30 seconds. After 5 minutes, the wireless earphones
will power off automatically.
USB-C
USB-A
Size
27(L)mm x 23(W)mm x 23(H)mm
Weight
5g (each) x2
Battery capacity of the earphones
50mAh
Charging time of the charging box
About 2.5 hours
Working voltage
3.3V-4.2V
Standby time
5 minutes
Music playing time
7-8 hours
Talk time
7-8 hours
Bluetooth Version
5.3
Support for profile
Ten silica HiFi EP, Hardware FFT, SRC, Filter,
MCSync TWS+
RF emission frequency
Class 2
Transmission category (Hz)
2.402 GHz 2.480 GHz
Transmission distance
10 m
Audio sampling accuracy
16 bits
Audio sampling rate
Up to 96 kHz
Audio coding format
CVSD, mSBC, SBC, AAC
Noise-signal ratio
>95 dB
Working temperature
-15°C~60°C
Working wet
10%~85~% (Non-freezing state)
Headphones
Specifications
Ø6 mm
Impedance
32 /typ
Frequency (Hz)
20Hz-20KHz
Sensitivity
93 ±3dB
Input power
3mW~5mW
Microphone
MIC type
Silicone microphone
MIC sensitivity
-42±1dB
SPL
130dB
SPECIFICATIONS
NOTES
Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

Kogan KAA45BLUBUDS User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI