Bluetooth 4.1 sports headphones
Instrucon manual
Charging the headset
1. During charging, the indicator light will be red.
2. When the headset is fully charged, the red light will turn blue, please unplug the charger.
Issues that require aenon
Because the Bluetooth headset has small capacity lithium baeries, charging should use original
charging equipment and according to the following instrucons:
Charging voltage: 5V
Charging current: 500 Ma
Charging me: 1 hour, or when the light turns blue.
Note: Failure to charge according to this guide may damage the headset, in extreme cases even
cause an explosion, as well as render any failure out of warranty for this product.
To pair the headset to a Bluetooth enabled cell phone
A. Turn the headset on, in standby mode.
B. Set the phone to scan for Bluetooth devices
C. When the phone nds the headset, conrm by selecng the headset from the list.
D. Enter the passcode 0000 when prompted by the phone.
E. Repeat the steps if the pairing was not successful, it is only necessary to pair once (if the
pairing was successful, it starts ashing blue, indicang that it is in standby mode and ready to
receive calls)