water or any other liquid.
9. Do not reach for the cradle or charger cord unit that has fallen into water, unplug immediately
before retrieving it. Failure to unplug the device may result in electric shock!
10. Keep the cord away from heated surfaces.
11. Do not attempt to open the Brush Handle for any reason, it will be irreparably damaged after
doing so.
12. Do not plug into an incorrect voltage source outlet, use only with appropriate voltage (100-
240V AC).
13. Batteries must not be taken apart, thrown into re or short circuited. You should never charge
the batteries with any charger other than the supplied charging cradle.
14. If a battery has leaked, avoid contact with the skin, eyes and mucous membranes. If necessary,
rinse the aected areas with water and seek medical advice.
15. The battery must be removed from the appliance before it is scrapped.
16. The appliance must be disconnected from the mains power supply before removing the battery.
17. The battery must be disposed of safely.
18. Internal batteries cannot be replaced. To dispose of batteries, the recycling of the entire device
at your local recycling center is good for the environment.
19. The device should only be used with an adapter of the output voltage and power as specied
on the cradle.
Charging
The SonicCleanPlus has been outtted with an induction charger and charging cradle for easy charging.
1. Make sure device is aligned in charging cradle for charging - a red light will blink indicating that
the device is charging. A full charge is indicated by a constant red light.
2. The SonicCleanPlus may show a “constant red” light (indicating full charge) when charged for the
1st time – this is normal since each product is fully checked before shipment. If you’re charging
for the 1st time and the charging light is “blinking red” – still charge the device to get a “full”
charge prior to rst use.
3. IMPORTANT: Make sure device is dry before placing into the cradle for charging. For best results
charge your SonicCleanPlus for 16 hours prior to rst use. On a full charge, the SonicCleanPlus
will provide approximately 2 hours of use in high speed, and 2.5 hours in low speed output. Sim-
ply place SonicCleanPlus into the Cradle, plug the charger cord (adaptor) into any wall socket
and the connector cord into the bottom of the charging cradle (making sure to loop the cord
through the channel on the bottom of the cradle. The SonicCleanPlus features an over charge
protection feature so the device can always be kept in the charging cradle. Silk’n recommends
to unplug and conveniently store the charging adaptor after each full charge until charging is re-
quired. You can leave the SonicCleanPlus in the cradle as a counter top stand when not charging.
Micro-Fiber bristle brush applicators – Attach and remove
To attach a brush head, place the center of the brush head on the matching hexagonal attachment
point located on the device. Press the center of the brush head and push down until it snaps into
place.
To remove the brush head, simply grip the outer plastic base of the brush head rmly in one hand
and the device handle in the other hand and pull up evenly until it snaps loose.
Using SonicCleanPlus facial brush
SonicCleanPlus high frequency vibration cleansing applicator. Use daily to remove the epidermal
(outer) layer of dry and aky skin cells.
With its 4 settings the SonicCleanPlus has an unprecedented versatility - this allows you to clean and
apply cream at your desired setting as well as massage your facial skin to improve blood circulation
(VIBRATING MODE) and improve elasticity (PULSATING MODE):
The SonicCleanPlus hand unit device is water-resistant for use in shower. Do no submerge device in
water or other liquids. When returning unit to the cradle ensure unit is completely dry
EN