TD-LTE digital mobile phone
Item
Name Function
1
2
3
4
5
6
7
8
9
10
11
Customizable
key
Volume keys
SOS key
Front camera
Flash
A custom shortcut function key
Adjust volume
SOS key
Earphone jack
When earphones connected,
also doubles as antenna for FM
radio to function
Receiver
Outputs call audio
Recent apps
key
Tap to show recently used
apps
Home key
Tap to return to the home
screen
Back key
Tap to return to previous menu
or exit the running application
Able to charge phone via
these strips
External charg-
ing strips
Micro USB port
For data I/O and for charging
Power key
Start up or Shut down
Long press to open mobile
phone mode and
12
Camera key
Short press to open to camera
Rear camera
Camera flash and torch
Speaker
Outputs sound
13
14
15
16
1
2
3
4
5 6
7
8
9
10
11
12
13
16
14
15
-01-
-02- -03- -04- -05- -06-
Rg720
SIM card/Micro SD card installation and
removal, the back cover lock and unlock
When you order a mobile phone service, you will receive a
Subscriber Identity Module (SIM) card that contains your
order details, such as a personal identification number (PIN)
and optional service.
The SIM card slot of this device is only suitable for
conventional standard SIM cards and small cards (if a SIM
card is smaller than a conventional card, please use a
suitable card holder), inserting an unauthorized SIM card or
SD card may cause damage to the SIM card and SD card
slot of this device.
Firstopenthebackcover.
When installing the SIM card or SD card, turn up the sheet
metal under the direction marked on the sheet metal. Insert
the SIM card in accordance with the slot prompt direction as
the following picture. The chip of the card should be down.
Put the chip of SD card down and insert the corresponding
slot. In the end, push down the slot on the sheet metal and
buckle in place.
SI M1
SI M2
SD
Insert the back cover into the back cover slot and press it
closely as per the following picture, then close the back
cover as shown below.
Note: Please shut down before removing the SIM card or
memory card, and then remove the SIM card or SD card
from the SIM card or SD card slot in the opposite direction.
Note: After installation is complete, be sure to tightly battery
cover, tightening the battery cover screw lock,to avoid the
damage of water or dirt entering the mobile phone.
Only RugGear battery cover and accessories can be used.
Insert / pull out the memory card tip:
To store additional multimedia data, you must insert a
memory card that accepts up to 64GB.Please make sure to
remove the memory card under safe condition.
1. Choose "Settings" → "Save" → "Unload Storage device"
→ "OK".
2. Please remove the memory card after shutting down.
Waterproof and dust proof usage strategy
Your device has been tested and proved in certain
conditions with waterproof and dustproof performance In
accordance with international standard IEC 60529.
IP level as follows:
without protection without protection
There is no effect when water
drops drop on the cover
When mobile phone tilts to 15
degrees, there is no effect
when water drops drop on the
cover
There is no effect that water
drops from 60 degrees onto
cover.
There is no effect that when a
liquid is splashed on the
mobile phone in any direction
Rinse with water without any
damage. There is no effect
when the mobile phone is
flushed with water
Prevent large solid
from intrusion
Prevent middle solid
from intrusion
Prevent small solid
from intrusion
Prevent substance
bigger than 1 mm from
intrusion
Prevent harmful dust
from accumulating
0
1
2
3
4
5
0
1
2
3
4
5
Quick Start Manual
Power Idea Technology (Shenzhen) Co., Ltd.
Frequency bands
GSM 900
DCS 1800
WCDMA 900
WCDMA 2100
LTE Band 1
LTE Band 3
LTE Band 5
LTE Band 38
LTE Band 39
LTE Band 40
WiFi
BT
Maximum output power
33dBm
30dBm
23dBm
23dBm
23dBm
23dBm
23dBm
22dBm
23dBm
22dBm
17dBm
7dBm
-07-
-08- -09- -10-
6
6
The mobile phone can be
used in a cabin environment.
The mobile phone can soak
for a short time
The mobile phone can soak
under a certain pressure in a
long time
7
8
completely prevent
dust from entering the
mobile phone
In order to avoid water or dust on your phone,
please strictly follow the following tips:
Make sure that the battery cover of the phone, the battery
cover screw lock, the headset and the USB interface are fully
closed to prevent dust and water. Be sure to clean off the
battery cover.
Do not expose your phone to an environment with water, such
as waves or waterfalls.
Do not expose your phone to brine, water, or soapy water.
Do not use in hot springs or high temperature water, waterproof
soft side cannot be high temperature, otherwise it will lead to
water.
Do not open the battery cover with wet hands or when the
phone is wet. Open the cover to open the cover to prevent the
inside of the cover from flowing into the compartment.
Do not open the phone's battery cover when immersing the
phone in water or in a very humid environment. (Such as
swimming or in a bathroom)
Do not open the battery cover when the body is not completely
dry
Do not clean the product with chemicals such as
detergents.
The rubber seal on the inside of the battery cover is an
important part of the phone. Be careful when opening or
closing the battery cover to avoid damaging the rubber
seal. Before closing the battery cover must ensure that
there is no debris on the seal, such as sand, dust, hair and
other debris, so as not to affect the battery cover tightly
closed.
If the phone is dropped or bumped, the battery cover and
the multifunction jack cover may be loose. Make sure that
all covers are properly aligned and tightly closed.
The phone's waterproof design makes it possible to vibrate
under certain conditions. Under these conditions (such as
when the volume is high) the vibration is normal, and will
not affect the performance of the phone.
If you are doing outdoor activities, and your phone
accidently falls into mud, rinse it with water.
If you accidentally fill your fuselage on the beach, rinse it
with water.
If the phone is immersed in water or the microphone or
speaker is wet, the person may not be able to hear your
voice during a call. The water must be dried and wiped with
a dry cloth to ensure that the microphone or speaker is
clean and dry and then air dried. Do not use a hair dryer to
dry.
If water droplets are attached to the screen, the touch
screen may be affected, resulting in an operation error. It is
recommended to dry water droplets and then continue to
use.
Extended battery life tips:
There are many features in the device that will increase
power consumption, thereby reducing battery life, you
can:
1. Turn off these radio functions when not using Bluetooth
connectivity, Wi-Fi, or GPS positioning;
2. Lower the phone screen brightness and set a shorter
sleep time can save power, you cannot use the device
when the power button to close the screen;
3. Close the Email, calendar and contacts and other
applications of automatic synchronization; clear recent
apps by tapping the “recent apps” key;
4. Clear recent apps by tapping the “recent apps” key
Security Information
Adapter shall be installed near the equipment and shall be
easily accessible.
The product shall only be connected to a USB interface of
version USB2.0.
Use careful with the earphone maybe possible excessive
sound pressure from earphones and headphones can
cause hearing loss.
The SAR limit of Europe is 2.0 W/kg. The device has
also been tested against this SAR limit. The highest
SAR value reported under this standard during
product certification for use at the ear is 1.30W/kg
and when properly worn on the body is 1.31W/kg.
This device was tested for typical body-worn
operations with the back of the handset kept 5mm
from the body. The device complies with RF
specifications when the device used at 5mm form
your body. The use of belt clips, holsters and similar
accessories should not contain metallic components
in its assembly. The use of accessories that do not
satisfy these requirements may not comply with RF
exposure requirements, and should be avoided.
Caution: risk of explosion if battery is replaced by an
incorrect type. Dispose used batteries according to
the instructions.
The phone's normal operating temperature is -10℃
～+50℃ .In order to ensure the normal phone
functions, do not use this phone outside the
temperature range.
Disclaimer
All content and services available through this device are
third parties and are protected by copyright, patents,
trademarks and other intellectual property laws, which are
used only for personal non-commercial use. You may not
be able to use any content or services when you do not
have permission from the content owner or service
provider.
Third party content and services are provided as is.
RugGear makes no warranties, either express or implied,
with respect to the content or services provided for any
purpose. RugGear is expressly disclaims any implied
warranties or conditions, either by law, by common
law or by any other means [including but not limited
to merchantability or fitness for a particular purpose].
IN ANY CONTENT (INCLUDING NEGLIGENCE),
ANY CONTENT OR TORT, ARISING OUT OF ANY
DIRECT, INDIRECT, INCIDENTAL, SPECIAL OR
CONSEQUENTIAL DAMAGES ARISING OUT OF
ANY CONTENT, Loss or damages, attorneys' fees,
expenses or any other loss or damage arising
therefrom, or the connection of any information
contained therein, or any use of any content or
services by you or any third party, RugGear Shall not
guarantee its accuracy, validity, timeliness, legality or
completeness.
Third-party services may cease or discontinue at any
time, and RugGear shall not be liable or warranties
for any period of time that any content or service may
be used. Content and services are transmitted by a
third party through a network and transmission
equipment other than RugGear control. In addition to
the generality of the disclaimer, RugGear also
expressly disclaims any liability or liability for any
interruption or delay in any content or service to
which this device applies.
RugGear has neither liability nor obligation to
customer service involving content and services. Any
service requirements related to content or service
should be directly addressed by the content and
service provider.
-11- -12-
This symbol on your product, the battery
and the accessories means that these
products must be taken to collection points
at the end of their life.
Address：4th Floor, A Section , Languang
Science&technology Building ,No.7 Xinxi RD , Hi-Tech
Industrial Park North , Nanshan District ,ShenZhen ,
P.R.C.
封
⾯
封⾯
最终效果
材质：80g书纸
70*110mm
/
