1 2 4
3
S42SWLH13
Quick Start Guide
Soundbar with
wireless sub-woofer
5
HDMI IN 1 HDMI IN 2 HDMI OUT
MP3 LINK
OPTICAL DC IN
COAXIAL
L AUX R
Unpacking
Connections
1. Attach the stand base to the stand support, using
2 screws A to screw the holes of the stand base to
the groove of the stand support.
2. Stick the 4 non-slip feet onto the bottom side of
the stand base.
Main Unit Sub-woofer Remote Control
(battery included)
Remove all items from the packaging. Retain the packaging.
If you dispose of it please do so according to any local
regulations.
Wall
Bracket x 1
Mains
Cable x 2
Screw B x 3
Dowels x 3
Mains
Adapter
Screw A x 2 Non-slip
Feet x 4
Stand Base
Instruction
Manual
Quick Start
Guide
Installing the Stand Base Battery Replacement for the Remote Control
The remote control requires a CR2032, 3V Lithium
battery (included).
QSG-S42SWLH13-130730V3
Thank you for purchasing your new Sandstrøm Soundbar.
Please follow this quick start guide for a successful first time set up.
We recommend that you spend some time reading the instruction manual in order
to fully understand all the operational features it offers.
Read all the safety instructions carefully before use and keep the instruction
manual for future reference.
Ensure all audio connections of the Soundbar are connected before connecting to the mains power socket.
STANDBY AUX MP3 LINK BT COAXIAL OPTICAL HDMI1 HDMI2
EQ S-BASS
OPTICALCOAXIAL
HDMI 2HDMI 1
MUTE
AUX/
MP3 LINK
VOL
+
VOL
–
Audio
L/R Cable
L-shaped
Adapter
Lithium Cell
CR2032
1. Press and slide the back cover to open the battery
compartment of the remote control.
2. Replace the old battery with a new one, with the
positive polarity (+) facing upward.
3. Close the battery compartment cover.
HDMI cable
(not included)
3.5mm to 3.5mm
stereo audio cable
(not included)
Audio L/R cable
(included)
Coaxial cable
(not included)
Optical cable
(not included)
To the mains
socket
Audio device
Stand Base
Visual device
Sub-woofer
Audio device
General Operation
Start Up
• In STANDBY mode, the STANDBY indicator will light
up red. Press STANDBY on the main unit or on the
remote control to turn the unit on.
• Press STANDBY to switch the unit back to
STANDBY mode.
• Disconnect the mains plug from the mains socket if
you want to switch the unit off completely.
Selecting Modes
Press SOURCE on the unit repeatedly to select the
desired mode, or press AUX / MP3 / / COAXIAL /
OPTICAL / HDMI 1 / HDMI 2 on the remote control.
Adjusting the Volume
Press VOL +/– to adjust the volume.
EQ (Equaliser)
Press EQ on the remote control to select the preset
equalisers.
BASS
Press BASS on the remote control to turn the bass ON
or OFF.
You will find that there are many exciting features available.
To get to know all these features, please take some time to read the instruction manual provided.
Tip:
Stand Support
Non-slip feet
ScrewA
S42SWLH13_QSG_RC_Final130730.pdf 1 30/07/2013 3:38 PM
-
1
