5
Unpacking
Check that the cooker hood has no damages.
Transportation damages should immediately be
reported to the one responsible for the transport
Damages, faults and eventually missing details
should immediately be reported to the seller.
Take care of the packing material so that small
children cannot play with it.
Placement
The hood is to be mounted on the wall.
When installed, the hood must be not less than
60 cm. above electric burners or 75 cm. above
gas or mixed-fuel burners. (Fig. 2).
Electrical connection
The hood has a power cord with moulded plug
to be connected to a wall outlet of 230 V.
The power cord length is 1,3 m.
Mounting the hood - Fig. 3
a. Put the template onto the wall (1)and drill two
Ø12mm holes (2).
b.Fit two hooks (3) on the drilled holes.
c. Remove the metal filters.
d.Hang the hood on the hooks and adjust the
position of the hood using the two screws on
the bottom of the hooks (5).
e. On the top of the cooker hood mark two
holes (6),
Remove the hood and drill two Ø8mm holes
on the marked points.
Fit two Ø8mm wall dowels (7), Hang again
the hood and fix the hood definitively with two
screws 5X45 (8) from the inside of thehood.
f. Refit the metal filters
Installation
Special accessories
Active carbon filter
When the hood is used in recirculation mode an
active carbon filter should be used.
Order by the retailer
PNC 942 120 389
Fig. 2
Mounting the chimney
g.Fix the chimney support (10) with two screws
5 x 45 mm (11) and two wall dowels (9) on
the wall close to the ceiling.
h. For exhausting version: Fit the connection
ring on the top of the hood with two screws Ø
3,5 x 6,5 mm (12S) then fit an axhausting
pipe long enough to reach the outside (13S).
For recycling version: first insert the fixing
nooses of the deflector (K) on the rear slot
(12K) then fix definitively the deflector (13K)
on the top of the hood with two screws Ø 3,5
x 6,5 mm on the front holes (12K) . Check
that the active carbon filters are mounted,
see Fig. 7.
i. Prepare the electric connection (14) (see
relative chapter).
j. Fit the chimney (15) and fix it on the chimney
support with two screws 3,0 x 9 mm (16).
The lower part of the chimney must be slided
down and inserted on the housing on the
upper part of the hood (17).
Remove the plastic film that protects the
chimney.
k. Fit the two grids (18) on both sides of the
chimney.
Min.
60 cm.
Min.
75 cm.