Shark S4701 Quick start guide

Brand: Shark

Model: S4701

Type: Quick start guide

For more information, please visit sharkclean.com

or call us at 1-800-798-7398.

1. Prep:

a. Remove the Mop Handle and Pole.

b. Push the button to detach the Mop Head.

c. Attach the Accessory Hose.

d. Select the Accessory of choice and attach to end of Accessory Hose.

Step 1.

Attach the Pad.

Step 2.

Insert the Direct Steam Nozzle

into the Scrub Blast Accessory.

Step 3.

When you press the Steam Control Button, ACCESSORY Mode

will automatically be selected. Steam will blast from the front tip

of the Accessory—press the Accessory against the surface you

wish to clean, and the steam will redirect into the Pad. Continue

to press the Accessory down as you clean.

EASY ASS E M B LY

CLEAN

in 2 EASY STEPS

ABOVE-FLOOR CLEANING

in 2 EASY STEPS

USING YOUR ABOVE-FLOOR

SCRUB BLAST ACCESSORY

Please note that some accessories may not be included

with your product. See box for speciﬁc product details.

All accessories and pads can be ordered through

customer service 1-800-798-7398.

Scrub Blast Accessory

Steam Duster Accessory

EZ Reach Bending

Duster Accessory

Total Clean

Pocket Accessory

Precision Clean

Pocket Accessory

1. Insert the Mop Handle into the Mop Body.

Push until you hear it “click” into place.

2. Attach the Mop Head to the Mop Body.

3. Attach Blast & Scrub Pad to the Scrubber.

2. Clean:

• To select the ACCESSORY Steam Setting press the Steam Control

Button once (LO and HI Modes are not available for above-ﬂoor cleaning).

• Begin cleaning.

• Allow to dry.

Flat Scrubber

Accessory

Direct Steam

Nozzle

*Sanitize with Rectangle Mop Head only, not in Blast & Scrub Mode and not with above-ﬂoor accessories.

Not for use on unsealed ﬂoors. See Owner’s Guide for instructions.

*Sanitize with Rectangle Mop Head only, not in Blast & Scrub Mode and not with above-ﬂoor accessories.

Not for use on unsealed ﬂoors. See Owner’s Guide for instructions.

CAUTION: Make sure the Steam Mop is unplugged or in Standby Mode while

attaching or removing the Scrub Blast Accessory. Avoid touching

the Accessory, as it will be very hot after steaming.

CAUTION: It is recommended that you allow the Pad to cool off before

removing it from the Accessory to avoid possible scalding injury.

Cleaning Tip: The Scrub Blast Accessory is ideal for cleaning

large surfaces. Its design allows you to apply more force when

scrubbing, which redistributes the steam toward the Pad when

pressed against a surface.

Scrub Side

provides added scrubbing power

when and where you need it.

Shaggy Side

ideal for general cleaning

over large areas.

Please be sure to read the enclosed Owner’s Guide prior to using your unit.

Steam

Pocket

Mop

BLAST & SCRUB

-in-

SUPER-HEATED STEAM SANITIZES

WITH NO CHEMICAL RESIDUE

1. Prep:

• If not already attached, attach

the Pocket Pad to the Mop Head.

• Fill the Water Tank to the “Fill Line”.

• Plug in.

2. Clean:

• Select a Steam Mode: LO or HI

(the ACCESSORY Mode is not available for ﬂoor cleaning).

• Begin mopping. Flip the Steam Mop

over as needed to use both sides of

the Pocket Pad.

• Allow to dry.

NOTE: To prolong the life of your Steam Mop, we recommend using distilled water.

NOTE: Within 30 seconds, you will hear a hissing sound followed by visible steam.

NOTE: When the Steam Mop is out of water, you will hear a loud gurgling sound—

you can reﬁll the steam mop at any time as long as the unit is unplugged.

SECONDS!

STEAMS IN

DANGER OF SCALDING: Steam emitted is very hot.

Use caution when using the steam mop.

FOR THE TOUGHEST STUCK-ON MESSES

CAUTION: DO NOT USE SCRUBBER ON ABOVE-FLOOR SURFACES.

Making sure the Mop Body is fully upright, pull it up

and off the Mop Head. This will ensure the Mop Head

is easy to re-dock.

BLAST & SCRUB

TECHNOLOGY

STEP 1

STEP 2

Push the ENGAGE SCRUBBER/HEAD RELEASE BUTTON

on the back of the Mop Body to remove the Mop Head.

1. Press Release Button

2. Remove Mop Head

When you place the Mop Body on the ﬂoor, the Stain

Scrubber will automatically move into position. The

Stain Scrubber can be used in LO or HI Steam Modes.

Re-dock the Mop Body on the Mop Head to continue

regular cleaning.

3. Scrub Away Stains

STEP 3

**Does not include Above-Floor cleaning mode.

Step 1.

Attach the Pocket Pad.

Step 2.

Insert the Direct Steam Nozzle into

the EZ Reach Bending Duster Accessory.

Step 3.

When you press the Steam Control Button, ACCESSORY Mode will

automatically be selected. When you see the steam, start cleaning!

Easy Cleaning

When you press the Steam Control Button,

ACCESSORY Mode will automatically be selected.

When you see the steam, you can start cleaning.

USING YOUR EZ REACH

BENDING DUSTER

USING YOUR DIRECT STEAM NOZZLE

Cleaning Tip: The EZ Reach Bending Duster Accessory

extends and bends to dust hard-to-reach places.

Cleaning Tip: The Direct Steam Nozzle is

great for blasting away tough messes with

a burst of super-heated steam.

NOTE: To bend the accessory into the desired position, pull back on the buttons

on the sides of the EZ Reach Bending Duster Accessory.

S4701_QSG_EB3

Shark S4701 Quick start guide

Shark S4701 Quick start guide

Shark S4701 Quick start guide

Related papers

Other documents