Dakota Digital VHX-61C-IMP Installation guide

Hello! I am an AI chatbot trained to assist you with the Dakota Digital VHX-61C-IMP Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

Manual # 650399B

VHX-61C-IMP

Dakota Digital VHX Instrument Installation

For 1961-‘62 Chevy Impala

Your new VHX-61C-IMP kit includes:

Control Box

CAT5 Cable

Universal Sender

Pack

Installation Manuals

VHX Display

(2) Mounting nuts

U-brackets (3X)

Plastic Thumb

nuts (6x)

Manual # 650399B

Installation

1. Remove the stock gauges from the dash.

2. Insert the three satellite cans from the front of the dash; from left to right: Temp, Tach, Oil. Use the

U-brackets and thumb nuts to secure the gauge to the dash while maintaining proper alignment.

3. Place the main gauge over the factory studs. Use the two nuts provided to secure it.

Manual # 650399B

5. Connect the CAT5 cable to the system. As the assembled cluster is installed into

the dash, take care when routing this cable to the control box.

4. Connect the ribbon cables

to their respective ends.

Manual # 650399B

WARNING: This product can expose you to chemicals including lead, which is known to the State of

California to cause cancer and birth defects or other reproductive harm. For more information go to

www.P65Warnings.ca.gov

6. Refer to the main manual for wiring instructions to complete the VHX installation.