2. Danfoss
  3. Accessorie circulation pump kit electrical connections 6-13kW, 16-18kW

Danfoss Accessorie circulation pump kit electrical connections 6-13kW, 16-18kW Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Danfoss Accessorie circulation pump kit electrical connections 6-13kW, 16-18kW Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Installation Guide
Accessorie, circulation pump kits
086L0626, 6-13kW (Para 25/1-7), 086L0627, 16-18kW (Para 25/1-11)
© Danfoss A/S (Dept./Init.), 2013-11 VIILA 102 1
086L2984
086L2984
2 VIILA 102 © Danfoss A/S (Dept./Init.), 2013-11
Wilo-Stratos PARA circulation pumps, electrical connections
General
These instructions describe the electrical connections of the Wilos-Stratos PARA circulation pumps. These pumps are equipped with a
mains cable or, depending on the available functions, with a mains and control cable as standard. The installation kits are as follows:
• 086L0626 Circulation pump kit 6-13kW (Para 25/1-7)
• 086L0627 Circulation pump kit 16-18kW (Para 25/1-11)
Safety precautions
C Installation must be carried out by an authorized electrician and must comply with applicable local rules, regulations and these instruc-
tions.
C The connectors are live and may cause fatal electrical shocks. The power supply must be disconnected before the electrical installation
begins.
Overview
The picture below shows electrical and signal connections from the circulation pump to the control unit of the heat pump.
N
N
N
N
F2 F2
L1.1 L1.1
101.2101.1
101.4101.3
101.6101.5
101.16
101.8
102.4102.3
102.6102.5
102.8102.7
L1
N
PE
L1
N
PE
N
N
N
N
110
COM
111
113
114
116.1
118.1
COM
COM
COM
COMCOM
116.2
118.2
atec-014
N
PE
101.1
COM116.2
116.1
© Danfoss A/S (Dept./Init.), 2013-11 VIILA 102 3
Mains connection, 3-core cable
For mains power supply 1-230V/50Hz:
Control , 4-core cable
For connecting the analogue interfaces 0-10V or PWM as well as assigning the collective fault and run signal contacts:
116 ,2COM COM 116 ,1
101,1
4 VIILA 102 © Danfoss A/S (Dept./Init.), 2013-11
Danfoss Heat Pumps
Box 950
671 29 ARVIKA
Phone +46 570 81300
E-mail: dhpinfo@danfoss.com
Internet: www.heating.danfoss.com, www.thermia.com
Danfoss assumes no responsibility whatsoever for any errors occurring in catalogues, brochures or other printed material. Danfoss reserves the right to make changes to (the design of) its products
with no prior warning. The same applies to products already on order provided that the previously agreed specications remain unchanged. All trademarks in this material are the property of the
respective company. Danfoss and the Danfoss logotype are trademarks which belong to Danfoss A/S. All rights reserved.
/