UNICOM VAA-FS2AG-XX Installation guide

Type
Installation guide

UNICOM VAA-FS2AG-XX: Composite Wall Mount Audio/Video Module

UNICOM VAA-FS2AG-XX is a high-quality audio/video module that allows you to enjoy crystal clear sound and pictures over long distances using economical Category 5e or higher UTP cable. It is perfect for home theater and residential audio/video applications.

The module features one RCA female connector for video and two RCA jacks for left and right audio. It also has a 110-type rear punchdown input for easy and secure cable termination.

With a bandwidth of DC~12 MHz for video and 50 Hz~15 KHz for audio, the module ensures excellent signal quality. It supports distances of up to 100 meters for black & white video, color video, and audio.

UNICOM VAA-FS2AG-XX: Composite Wall Mount Audio/Video Module

UNICOM VAA-FS2AG-XX is a high-quality audio/video module that allows you to enjoy crystal clear sound and pictures over long distances using economical Category 5e or higher UTP cable. It is perfect for home theater and residential audio/video applications.

The module features one RCA female connector for video and two RCA jacks for left and right audio. It also has a 110-type rear punchdown input for easy and secure cable termination.

With a bandwidth of DC~12 MHz for video and 50 Hz~15 KHz for audio, the module ensures excellent signal quality. It supports distances of up to 100 meters for black & white video, color video, and audio.

Installation guide
Rev. 041708
( Continued )
READ ALL INSTRUCTIONS
Cable Handling Guidelines
Do not route audio/video cables through the same
cable holes as the AC power cables.
For safety, all audio/video cables should be separated
from parallel AC power lines by at least 6 inches
whenever possible.
Avoid kinking the cable.
Do not attach cable tie-downs too tightly. The cable
fastening hardware should not compress the cable
sheath.
Do not bend the cable sharply. Be especially careful
to dress the cables properly after passing them
through a hole as the edges of the hole can
compress or even damage the cable sheath.
Follow all warnings on the products.
For your safety, do not use this or any electrical
product near water (unless specifically designed for
wet areas).
Do not install wiring during thunder and lightning
storms.
Use caution when handling or installing any
computer, telephone, video, or electrical devices.
Specifications:
Interface: Video: One RCA female connector (gold)
Audio: Two RCA jacks for Left and
Right Audio (gold plated)
UTP: 110-type rear punchdown input
Impedance: Video: 75 ohm Unbalanced
Audio: 600 ohm Unbalanced
UTP: 100 ohm balanced
Bandwidth: Video: DC~12 MHz
Audio: 50 Hz~15 KHz
Distance: Black & White Video, Color Video,
and Audio:
Up to 100m. on Category 5e UTP cable
Colors: Electric White and Electric Ivory
110-type: Pair 1: -No Connection-
Pair 2: Audio (right) signal
Pair 3: Audio (left) signal
Pair 4: Composite Video (V)
Overview: This guide will facilitate the installation of the Composite Wall Mount Audio/Video
M
odule (listed below). Also discussed are cable handling guidelines.
Product: Composite Wall Mount Audio/Video Module
part number: VAA-FS2AG-EW (Electric White)
VAA-FS2AG-EI (Electric Ivory)
Tools
you’ll need:
UTP Termination Tool, Wire Cutters
UNICOM Electric, Inc.
908 Canada Court
City of Industry, California 91748
U.S.A.
www.unicomlink.com
Technical Support: 1.800.346.6668
International: 626-964-7873
UNICOM’s 5 Year Product Warranty will warrant that all UNICOM
products
*
will be free from defects in material and workmanship
for a period of 5 years from the original date of purchase.
*
Excludes all UNICOM testers and Industrial Switches.
See www.unicomlink.com for more information
Unicom’s Composite Wall Mount Audio/Video Module is a
logical step in the evolution of home theater and residential
audio/video components. This module will provide crystal
clear sound and pictures over long distances utilizing
economical Category 5e or higher UTP cable. Follow the
simple instructions below to start enjoying your quality
Unicom product.
Installation Instructions
1) Strip off approximately 2" of the Category 5e cable
jacket, using the appropriate cable stripping tool.
2) Separate the pairs according to color (Blue-White/Blue,
Orange-White/Orange, Green-White/Green, and Brown-
White/Brown).
3) To terminate, place each wire into the insulation
displacement contacts (IDC) by matching the wire color
with the applicable colors on the punchdown block
(see fig. 1).
TIP: We recommend untwisting the pairs no more
than 1" from termination point.
4) If using a 110-type punchdown tool (p/n: TLP-P110),
place the tool over each wire with the cutting blade
facing outside of the IDC and punch down firmly.
5) Repeat this process with each pair.
6) Install included termination caps firmly onto the IDC.
7) Fasten insert and wallplate to electrical box using
supplied screws.
That’s it! Now you’ve made all of the necessary
connections. Enjoy your Unicom Composite Wall Mount
Audio/Video Module.
Composite Wall Mount
Audio/Video Module
Side view (fig. 1)
©UNICOM 2008. UNICOM is a trademark of UNICOM Electric, Inc.
All Rights Reserved.
UNICOM Electric, Inc.
908 Canada Court
City of Industry, California 91748
U.S.A.
www.unicomlink.com
Technical Support: 1.800.346.6668
International: 626-964-7873
Composite Video and Audio IDC Pin-out
(fig. 2)
110-type IDC (see fig. 2)
Stereo Right
(red)
Stereo Left
(white)
Video
(yellow)
wht/org
wht/brn
grn
wht/grn
org
brn
wht/blu
blu
No Connection
Right (red)
Left (white)
V
(yellow)
Audio
Video
Pair 1
Pair 2
Pair 3
Pair 4
  • Page 1 1
  • Page 2 2

UNICOM VAA-FS2AG-XX Installation guide

Type
Installation guide

UNICOM VAA-FS2AG-XX: Composite Wall Mount Audio/Video Module

UNICOM VAA-FS2AG-XX is a high-quality audio/video module that allows you to enjoy crystal clear sound and pictures over long distances using economical Category 5e or higher UTP cable. It is perfect for home theater and residential audio/video applications.

The module features one RCA female connector for video and two RCA jacks for left and right audio. It also has a 110-type rear punchdown input for easy and secure cable termination.

With a bandwidth of DC~12 MHz for video and 50 Hz~15 KHz for audio, the module ensures excellent signal quality. It supports distances of up to 100 meters for black & white video, color video, and audio.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI