Skyjacker SBE120, SBE320 Installation guide

  • Hello! I've reviewed the Skyjacker installation instructions for the SBE120, SBE124 and SBE320 double disconnect sway bar endlinks. This document provides step-by-step guidance on removing old parts, drilling mounting holes and installing the new endlinks, as well as specific information regarding bolt sizes, bushing lubrication, and ensuring correct offset during the mounting process. I'm ready to assist with your questions about these instructions or the product itself.
  • What should be done with the original sway bar endlink?
    What size bolt is needed for mounting the bracket to the sway bar?
    Where does the top bolt of the end link need to be when installed?
Remove the sway bar end link's lower
bolt at axle housing on both sides (see picture
#1). Remove top of sway bar endlink and dis-
card.
NOTE: Sway bar end must be drilled or
filed to allow clearance for the provided 7/16" x
1 1/2" bolt (see arrow in photo #2). The new
end link mounting bracket should be mounted
to the bottom of the sway bar with the bolt
pointing up through the sway bar and the nut
and 7/16 USS washer applied on top
(see picture 2). Apply lithium grease to the
polyurethane bushings. Insert them into the
end link eyes along with the metal sleeve (#54314). The top 1/2" x 2 1/2" bolt connecting the bracket to the end
link must be installed with the nut to the outside of the vehicle to provide adequate clearance to the frame. Install
new double disconnect end links on the inboard side of the axle bracket, being sure that the offset is turned
inward.(see picture #3).
DOUBLE DISCONNECT
SWAY BAR ENDLINKS
INSTALLATION INSTRUCTIONS
Part # SBE120/124/320
Picture #1 Picture #2 Picture #3
Remove the sway bar end link's lower bolt
at axle housing on both sides (see picture #1).
Remove top of sway bar endlink and discard.
NOTE: Sway bar end must be drilled or
filed to allow clearance for the provided 7/16" x
1 1/2" bolt (see arrow in photo #2). The new
end link mounting bracket should be mounted
to the bottom of the sway bar with the bolt
pointing up through the sway bar and the nut
and 7/16 USS washer applied on top
(see picture 2). Apply lithium grease to the
polyurethane bushings. Insert them into the
end link eyes along with the metal sleeve (#54314). The top 1/2" x 2 1/2" bolt connecting the bracket to the end
link must be installed with the nut to the outside of the vehicle to provide adequate clearance to the frame. Install
new double disconnect end links on the inboard side of the axle bracket, being sure that the offset is turned
inward.(see picture #3).
DOUBLE DISCONNECT
SWAY BAR ENDLINKS
INSTALLATION INSTRUCTIONS
Part # SBE120/124/320
Picture #1
I-SBE120/124 (3/02)
I-SBE120/124 (3/02)
Picture #2 Picture #3
Outboard
Outboard
/