Viessmann 6013 is an LED light or spot with wall holder. It is designed for model train layouts and dioramas. The light is produced by SMD-LEDs chosen to match the lamp model. It has low heat build-up and power input, and nearly unlimited lifetime of the LED.
The device can be connected to a model train transformer or a digital command station with an authorized operating voltage. For DC voltage, the diode should be connected to the positive pole and the resistor to the negative pole of the power supply. For AC voltage, a Viessmann power module (item 5215) is recommended to prevent flickering. One power module is sufficient for approximately 100 LED lights or spots. The cable with the diode should be connected to the brown output socket and the cable with the resistor to the yellow output socket.
Viessmann 6013 is an LED light or spot with wall holder. It is designed for model train layouts and dioramas. The light is produced by SMD-LEDs chosen to match the lamp model. It has low heat build-up and power input, and nearly unlimited lifetime of the LED.
The device can be connected to a model train transformer or a digital command station with an authorized operating voltage. For DC voltage, the diode should be connected to the positive pole and the resistor to the negative pole of the power supply. For AC voltage, a Viessmann power module (item 5215) is recommended to prevent flickering. One power module is sufficient for approximately 100 LED lights or spots. The cable with the diode should be connected to the brown output socket and the cable with the resistor to the yellow output socket.
Viessmann 6013 is an LED light or spot with wall holder. It is designed for model train layouts and dioramas. The light is produced by SMD-LEDs chosen to match the lamp model. It has low heat build-up and power input, and nearly unlimited lifetime of the LED.
The device can be connected to a model train transformer or a digital command station with an authorized operating voltage. For DC voltage, the diode should be connected to the positive pole and the resistor to the negative pole of the power supply. For AC voltage, a Viessmann power module (item 5215) is recommended to prevent flickering. One power module is sufficient for approximately 100 LED lights or spots. The cable with the diode should be connected to the brown output socket and the cable with the resistor to the yellow output socket.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI