Installation Guide LED Floodlight
Prime-Line 15W – 300W
InnoGreen GmbH |Wilhelmstraße .1| D-64646 Heppenheim
Ph.+49(0)6252/7954770|Fax .+49(0) 6252/9668490| E-Mail info@innogreen.de| www.innogreen.de
Security advice:
Please read this installation guide carefully and attentive before you mount and connect the
LED PRIMELine floodlight
Disconnect the device from the electricity supply
The mounting and electrical connection of the LED PRIMELine floodlight should be made by
an electrician
Assembly
1. Don´t remove any single components from the device
2. All technical details are to be found on the device label
3. Please use expansion bolts expansion screws for assembling the device to the surface
4. Please note that a untighten wire is helpful for a better readjusting of the device
Connection
Connect the power supply unit with the blue (N) and black or brown core
(L) phase (the connection to the electricity cable or electricity
supply (NYM-J)).
Please apply wire end ferrule to flexible cores,
The protective conductor (PE) needs to be connected.
Caution: Never connect the protective conductor (PE/green-yellow wire)
with the blue, brown or black wire!
Important security notifications:
Risk of electrical shocks!
Instruct an electrician with the installation.
Risk of injuries!
Provide a secure and a perfect assembly at the surface.
Caution!
Only connect the LED floodlight with the supplied wire.
Protection class: IP65
According to EU regulated CE-guidelines.