2. Niigata seiki
  3. AP-PH3

Niigata seiki AP-PH3 User manual

  • Hello! I've reviewed the instruction manual for the Stylus AP-PH3, a replacement stylus for the AP-03 Pneumatic Engraver. The manual provides details on stylus replacement, including removing the cap and handling the sharp stylus with care. I am ready to answer any questions you have about the device or its specifications.
  • What is the stylus model?
    What is the shaft diameter of the stylus?
    What is the total length of the stylus?
    What is the weight of the stylus?
    What should I do if the engraver does not operate after replacing the stylus?
STYLUS for AP-03 AP-PH3
Model No.
INSTRUCTION MANUAL
Thank you for purchasing the replacement Stylus for the AP-03
Pneumatic Engraver.
Before Replacing your Stylus, please read this manual
thoroughly and use according to the procedures described.
Pick-Marker AP-03
For
I286-K 1601
SPECIFICATIONS
CAUTION
Size Shaft Diameter 2.9mm, Total Length38mm
Weight 4g
Modification of the Stylus may cause accident, injury, or damage
to product. Please do not modify under any circumstances.
Stylus is sharp. Handle with care and never point tip at person.
Use only as directed.
Remove Cap by rotating in
direction shown by the arrow. Cap Remove
Remove the Stylus from the
Cap and replace with the
new Stylus.
Cap Stylus
Spring
If Engraver does not operate after
replacing Stylus, please contact
distributor or place of purchase.
Pneumatic Engraving Perforator
/