LabSat LabSat 3 Wideband Quick start guide

Record

1. Connect the antenna to the ‘RF IN’ port on the

rear of the LabSat 3 Wideband.

www.labsat.co.uk

Quick Start Guide

2. Place the antenna in the middle of the car roof.

3. Ensure you have selected the correct record

settings (i.e. quantisation, bandwidth,

frequency).

4. Press the ‘REC’ button to start recording.

5. Drive the desired route.

TIP: Record at least 4 minutes of stationary data to allow for

acquisition later.

6. Press the ‘REC’ button again to stop recording.

www.labsat.co.uk

Quick Start Guide

Replay

1. Connect the Device Under Test to the

‘RF OUT’ port.

2. Use the up and down arrows to select the

desired scenario.

TIP: Four demo scenarios are pre-loaded on the SSD.

3. Press the ‘Play’ button. 4. The Device Under Test should now be receiving

the replayed satellite signal data, allowing

realistic and repeatable testing to be carried

out under controlled conditons.

This manual is also suitable for

Download PDF