37
Unpacking the Appliance
1. Remove the appliance from its packaging.
2. Remove all packaging material such as plastic lms,
ller material, cable ties and cardboard packaging.
3. Sensitive surfaces are possibly protected with foil.
Remove these foils.
4. Check the content for any missing parts.
5. In the event that the packaging content should be
incomplete or if damages are noticeable, do not operate
the appliance. Return it to the dealer immediately.
NOTE:
There may be dust and production residue on the
appliance. We recommend cleaning the appliance as
described under “Cleaning”.
Overview of the Components /
Scope of Delivery
1 Steam outlet opening
2 Cover (grinder / brewing head)
3 Permanent lter insert
4 Grinding insert
5 Bean container / ground coffee container / brewing head
6 Drip stop
7 Opening over the safety switch
CAUTION: Important!
Ensure that there is no coffee bean or ground coffee
on top of the opening before tting the cover.
8 Water tank lid
9 Water level display
10 Eyelet for storage of the cleaning brush
11 Basic appliance
12 Hot plate
13 Glass jug with lid
14 ON / OFF button (with indicator lamp)
15
button (with indicator lamp)
16 button (with indicator lamp)
17 button (with indicator lamp)
Not Shown
Measuring spoon
Cleaning brush
Notes for Use
Placement
• Place the automatic coffee maker on a stable and level
surface. Place the appliance in such way that it cannot
tip over.
• Do not place the appliance in close proximity to a gas or
electric stove or any other heat source.
Note About the Brewing Process
During the brewing process and depending on the degree of
grinding and the used amount, the coffee powder absorbs
a certain amount of water. That is why the quantity of coffee
might diverge from the quantity of water in the water tank.
European Regulations on Energy Saving
NOTE:
The European Directive 2009 / 125 / EC (Ecodesign Direc-
tive) incorporates measurements for energy saving.
The following applies to coffee makers: The keep-warm
period is limited to max. 40 minutes after which the appli-
ance turns off automatically.
You benet from better safety and lower energy con-
sumption.
Electric Connection
1. Ensure that your mains power corresponds with the
specications of the appliance. The specications are
printed on the type label.
2. Connect the mains cable to a properly installed and
earthed wall outlet. The indicator lamp in the ON / OFF
button will ash briey.
Function Buttons
The indicator lamp in the button displays the function.
Button Indicator Lamp Function
ON / OFF
Flashes
Appliance turned on;
Select function
Lights up Selected function active
Lights up
Grinding coffee beans for
2 to 3 cups
Lights up
Grinding coffee beans for
4 to 6 cups
Lights up
Brewing coffee with ground
coffee
Coffee Beans
CAUTION:
Use only roasted coffee beans for grinding. Coffee beans
that are raw, frozen or placed in liquid may damage the
grinder.
Selecting the Amount of Coffee Beans
The bean container holds approx. 40 g. The amount of cof-
fee beans you grind depends on your personal preferences.
The kind and the roasting of the coffee beans have an
additional impact on the taste.
• Fill only the amount of coffee beans into the grinder you
need for a cooking process.
• We recommend approx. 6 to 7 g coffee beans for one
cup of water (100 ml).