2. Koala Kare
  3. 310-44-KIT

Koala Kare 310-44-KIT Operating instructions

  • Hello, I've reviewed the document which provides instructions for replacing the strap on Koala Kare KB300 series baby changing stations. It includes steps for removing the old strap, attaching the new one, and securing the buckle. I'm ready to answer your questions about this process.
  • What tool is needed for the replacement?
    What hardware is included in the replacement kit?
    What should be removed in step 1?
Phillips Head
Screwdriver
Flat Head Phillips Screws
Quantity: 2
Strap
Quantity: 1
Buckle
Quantity: 1
KB310 & KB311, KB300 & KB301
Replacement Strap Instructions
Koala Kare Products
A Division of Bobrick
6982 South Quentin Street, Centennial, CO 80112-3945
Main: 303.539.8300 | Toll Free: 888.733.3456 | Fax: 303.539.8399
Website: koalabear.com | Email: customerservice@koalabear.com
©2021 Koala Kare Products, P/N 310-56 April 2021
Step 1:
• Open the baby changing station. Remove the screws
that secure the old strap and buckle to the unit. Discard
the old strap, buckle and screws.
Step 2:
• Use one of the supplied screws through the hole in the
chafe tab of the strap and into the hole of the bed that
is closer to the bed liner dispenser. Fig. 1
Step 3:
• Use the second supplied screw to install the buckle.
Make sure the buckle is positioned correctly. Fig. 2
Step 4:
• Grab the loose end on the strap and thread it through
the buckle. Check that the strap is held firmly in place
when buckle is depressed over it.
Step 5:
• Clean up and close the unit.
Fig. 1
Chafe Tab
Fig. 2
Tool Needed Hardware Provided
P/N 310-44-KIT
/