2. Hobart
  3. HCM450 Cutter Mixer Bowl Seal

Hobart HCM450 Cutter Mixer Bowl Seal User manual

  • I have reviewed the provided instruction sheet for the Hobart HCM450 Bowl Seal. This document contains specific instructions on how to remove, clean, and reinstall the bowl seal. I'm ready to answer your questions about the device described in the document.
  • How often should the bowl seal be cleaned?
    How do you remove the bowl seal?
    What should be done before reinstalling the bowl seal?
701 S. RIDGE AVENUE
TROY, OHIO 45374-0001
937-332-3000
www.hobartcorp.com
HCM450 CUTTER/MIXER BOWL SEAL
INSTRUCTION SHEET
Disconnect electrical power supply and follow lockout / tagout procedures.
NOTE: The bowl seal should be cleaned at least once per day or once per shift.
BOWL SEAL REMOVAL
Remove the bowl seal by unscrewing the seal cover (Fig. 1) and pulling out the rubber seal. There are
detents (Fig. 2) in the lower seal housing to allow gripping the seal. Wash, rinse and dry both parts.
FORM 45226 (June 2013) PRINTED IN U.S.A.
BOWL SEAL INSTALLATION
Reassemble seal and seal cover (Figs. 1 and 2). Be sure bowl area is properly cleaned before reinstalling
seal. Insert rubber seal into the lower seal housing (Fig. 3). Press the seal down fully into housing. Screw
seal cover onto housing fi nger tight (Fig. 4).
Fig. 3 Fig. 4
Fig. 1 Fig. 2
/