2. TP-LINK
  3. Archer D2 Router Fibre

TP-LINK Archer D2 Router Fibre Operating instructions

  • I have reviewed the provided user manual for the TP Link Archer D2 router. It outlines the steps for configuring the router for a Mercury network, including instructions for logging in, setting up the connection type, and handling password issues. Please feel free to ask any specific questions you have about the setup or the procedures mentioned in the document.
  • What is the default username?
    What is the default password?
    What should I do if the password is incorrect?
TP Link Archer D2 Fibre Configuration
Using your own router? No worries, we’ve got you covered!
Log into the gateway:
1. Connect your device to the router (preferably via cable)
2. Open a web browser
3. Type the following in the address bar at the top: 192.168.1.1
4. Default Username: admin
5. Default Password: admin
6. This should then give you access to the router’s User Interface
If the password is incorrect you will need to factory reset the router by pushing and holding the ‘Inset Reset’ button for 10
seconds.
How to add correct settings for the Mercury network:
1. From the top menu select ‘Advanced’
2. From the left menu select ‘Operation Mode’
3. Select ‘Save’ – the router will now reboot
4. From the top menu select ‘Basic’
5. From the left menu select ‘Internet’
Ensure the following settings are changed:
1. ISP List – ‘Other’
2. Connection Type – ‘PPPoE’
3. Password – ‘password’
4. Select – ‘Save’
The router will now reboot once again. When it reconnects, you should be connected to Fibre!
/