Philips SJA9190 User manual

Page is loading ...

3 Safety Instructions

6 Introduction

7 Installation

8 Operation

10 Troubleshooting and FAQs

11 FCC Information

14 Warranty

15 Technical Support

2

EN

Contents

Safety Instructions

When using your telephone equipment, basic

safety precautions should always be followed to

reduce the risk of fire, electric shock and injury

to persons, including the following:

1. Read and understand all instructions.

2. Follow all warnings and instructions marked

on the product.

3. Unplug this product from the wall outlet

before cleaning. Do not use liquid cleaners

or aerosol cleaners; use a damp cloth for

cleaning.

4. Do not use this product near water for

example, near a bath tub, wash bowl,

kitchen sink, or swimming pool, or in a wet

basement.

5. Do not place this product on an unstable

cart, stand or table, as the product may fall,

causing serious damage to the product.

6. Slots and openings in the cabinet and the

back or bottom of this product are provid-

ed for ventilation (to protect it from over-

heating) and should not be blocked or cov-

ered. The openings should never be

blocked by placing this product on a bed,

sofa, rug or other similar surface. This

product should never be placed near or

over a radiator or heat register. This prod-

3

EN

Safety Instructions

uct should never be placed in a built-in

installation unless proper ventilation is pro-

vided.

7. This product should be operated only from

the type of power source indicated on the

marking label. If you are not sure of the

type of power supply to your home, consult

your dealer or local power company.

8. Do not allow anything to rest on the power

cord. Do not place this product where the

cord will be abused by people walking on it.

9. Do not overload wall outlets and extension

cords, as this can result in the risk of fire or

electric shock.

10.Never push objects of any kind into this

product through cabinet slots, as they may

touch dangerous voltage points or short out

parts, resulting in the risk of fire or electric

shock. Never spill liquid of any kind on the

product.

11.To reduce the risk of electric shock, do not

disassemble this product, but take it to a

qualified serviceman, when service or repair

work is required. Opening or removing

covers may expose you to dangerous volt-

age or other risks. Incorrect reassembly

can cause electric shock when this product

is subsequently used.

4

EN

Safety Instructions

12.Unplug this product from the wall outlet

and refer servicing to a qualified service per-

sonnel under the following conditions: a)

when the power supply cord or plug is dam-

aged or frayed; b) if liquid has spilled into the

product; c) if the product has been exposed

to rain or water; d) if the product does not

operate normally when you follow the

operating instructions (adjust only those

controls that are discussed in the operating

instructions, as improper adjustment of

other controls may result in damage, often

requiring extensive work by a qualified tech-

nician to restore the product to normal per-

formance); e) if the product has been

dropped or the cabinet has been damaged;

f) if the product exhibits a distinct change in

performance.

13.Avoid using a telephone (other than a cord-

less type) during an electrical storm. There

may be a remote risk of electric shock from

lightning.

14.Do not use the telephone to report a gas

leak in the vicinity of the leak.

Save these instructions.

5

EN

Safety Instructions

Introduction

The SJA9190 lets you know who’s calling by

announcing the Caller’s telephone number

when the phone rings, without interrupting

what you’re doing. If the Caller’s telephone

number is not available, the unit will announce

“Number Unknown.” If the Caller has blocked

their telephone number, the unit will announce

“Number Blocked.”

Check the Package Contents

Check the package contents to make sure you

have the following items: talking Caller ID unit

and telephone line cord.

Care and handling of your batteries

Please read these instructions before installing

batteries.

Make sure to insert the batteries properly, fol-

lowing the symbols showing you the correct

way to position the positive (+) and negative (-)

ends of the batteries.

Replace batteries with the size and type speci-

fied by the device’s manufacturer. Remove all

used batteries from the device at the same

time, then replace them with new batteries of

6

EN

Introduction

the same size and type.

Don’t dispose of batteries in a fire—they may

rupture or leak.

Don’t mix old and new batteries, or mix differ-

ent types or makes of batteries. This can cause

rupture or leakage, resulting in personal injury

or property damage.

Don’t give batteries to young children.

Installation

Set up the product by installing three (3)

“AAA” batteries inside the battery compart-

ment on the underside of the unit. The unit will

also work with a compatible AC Adapter

(7.5VDC output with negative pin polarity.)

Plug one end of the telephone cord into the

telephone jack on the wall, and the other end

into either of the telephone jacks on the back

of the unit.

An extra telephone jack is provided on the

back of the unit for connecting a telephone or

7

EN

Introduction

Installation

other device at your option.

Screening telephone calls while you’re

at home

The talking Caller ID works with standard

(number-only) and deluxe (name and number)

Caller ID service available from your local tele-

phone company.

The unit identifies calls by announcing the

Caller’s ten-digit telephone number between

the first and second ring. If the call is coming

from a number that has been blocked, it will

announce “Number Blocked.” If the telephone

number is unidentified, the unit will announce

“Number Unknown.”

If the phone is still ringing, and you didn’t hear

the number being announced, just press the big

key and it will repeat the number.

Audibly Reviewing Calls

The unit stores the last ten calls in memory for

audible review. This is convenient for finding

out who called while you were out. There are

two ways to perform audible call review:

1. Press the big key to hear the date, time, and

telephone number of the most recent call in

the log. Subsequent pressing and releasing

this key will go further back into the call log

and announce information about earlier

8

EN

Operation

calls. Pressing the big key while an

announcement is in process pre-empts the

current announcement and goes to the next

call. After the final call is announced, the

unit beeps. Continued pressing will start

back at the top of the log again.

2. Hold down the big key for 2-seconds, and it

will announce the number of new calls fol-

lowed by the date, time, and telephone

number of every new call in the log. After

the final call is announced, the unit beeps.

Language Selection

The unit speaks in English and Spanish. To

change the selected language, hold down the

small key and momentarily press and release

the big key. The unit announces “January” in

the selected language.

Erasing Calls

To erase the calls in the audible call log, hold

down the big key for 4-seconds. The unit

beeps confirming the calls have been erased.

Volume Control

There are four volume settings - low, medium,

high, and off. To change the volume, press and

release the small key very quickly. You may

find it helpful to press the key using the eraser-

9

EN

Operation

end of a pencil. The key is designed so that it

is difficult to change the setting by accident. The

unit beeps reflecting the new volume setting. It

beeps twice to indicate the volume is turned

OFF.

If the volume is set to OFF, incoming calls will

not be announced. Calls reviewed while the

volume is OFF will be announced at medium

volume level.

Troubleshooting & FAQs

Having problems? Before contacting PHILIPS

or your dealer, check the following list of sug-

gestions. You might be able to solve the prob-

lem yourself.

Question:

My unit does not announce anything when the

phone rings.

Answers:

Make sure the volume is turned up. To turn up

the volume, press the volume control button

(small button) with your finger or a pencil eras-

er until you hear the unit “beep” at the desired

volume level. If you hear the unit beep twice,

then the volume is off.

10

EN

Operation

Troubleshooting & FAQ

Make sure the batteries are installed properly.

The POSITIVE and NEGATIVE ends of the bat-

teries must line up according to the installation

diagram inside the battery compartment.

Make sure you have connected the telephone

cord between the telephone wall jack and one

of the telephone jacks on the back of the unit.

Make sure you have subscribed to Caller ID

service from your local telephone company.

Wait for the second ring before answering the

phone. The Caller ID information is received

between the first and second ring.

Make sure you have a fresh set of Alkaline bat-

teries installed, or that you are using the

optional AC adapter.

FCC Part 68 and ACTA

Information

Your Caller ID unit has been registered with

the Federal Communications Commission

(FCC), and it complies with the standards set

forth in part 68 of the FCC rules. The FCC

requires that we provide the following informa-

tion.

11

EN

Troubleshooting & FAQ

FCC Regulations

Connection and Use:

The FCC requires you to use a modular tele-

phone jack. This equipment may not be used

with party line service or coin-operated tele-

phone lines.

Notification of the Telephone Company

The FCC requires that upon request of your

local telephone company you provide the fol-

lowing information: the line to which you will

connect the Caller ID unit (your phone num-

ber), the Caller ID units FCC registration num-

ber and ringer equivalence number (REN)

(located on the back of your Caller ID unit),

and the USOC jack required (USOC RJ-11C or

RJ-11W). (note: the REN is useful in determin-

ing how many devices you may connect to your

telephone line and still have all of them ring

when someone calls your telephone number.

in most, but not all areas, the sum of all RENs

should be five or less. contact your local tele-

phone company for more information.)

Problems And Repairs

If your Caller ID unit is malfunctioning, the FCC

requires you to completely disconnect it until

12

EN

FCC Regulations

the problem has been solved. If your Caller ID

unit is harming the nationwide telephone net-

work, the telephone company may temporari-

ly discontinue your telephone service. The

telephone company will try to notify you

before discontinuing service. If advance notice

isn’t possible, the telephone company will noti-

fy you as soon as possible. you’ll be given the

opportunity to correct the problem, and you’ll

be informed of your right to file a complaint

with the FCC.

Your local telephone company may make

changes in facilities, equipment or operations

that affect the proper functioning of your Caller

ID unit. If such changes are planned, you’ll be

notified and advised of your right to file a com-

plaint with the FCC.

FCC Part 15 Radio Interference

Statement

This equipment has been tested and found to

comply with the limits for a class B digital

device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reason-

able protection against harmful interference in

a residential installation. This equipment gener-

ates, uses, and can radiate harmful radio fre-

quency, and if not installed and used in accor-

dance with the instructions, may cause harmful

13

EN

FCC Regulations

interference to radio communications.

However, there is no guarantee that interfer-

ence will not occur in a particular installation. If

this equipment does cause harmful interference

to radio or

television reception, which can be determined

by turning the equipment off and on, the user is

encouraged to try to correct the interference

by one or more of the following measures:

reorient or relocate the receiving antenna;

increase the separation between the equip-

ment and receiver; connect the equipment to

an outlet on a circuit different from that to

which the receiver is connected; consult the

dealer or an experienced radio/TV technician

for help.

One-Year Limited

Warranty

Philips warrants that this product shall be

free from defects in material, workmanship

and assembly, under normal use, in accor-

dance with the specifications and warnings,

for one year from the date of your purchase

of this product. This warranty extends only

14

EN

FCC Regulations

Warranty

to the original purchaser of the product, and

is not transferable. To exercise your rights

under this warranty, you must provide proof

of purchase in the form of an original sales

receipt that shows the product name and

the date of purchase. For customer support

or to obtain warranty service, please call

919-573-7863. THERE ARE NO OTHER

EXPRESS OR IMPLIED WARRANTIES.

Philips’ liability is limited to repair or, at its

sole option, replacement of the product.

Incidental, special and consequential dam-

ages are disclaimed where permitted by law.

This warranty gives you specific legal rights.

You may also have other rights that vary

from state to state.

Technical Support

For Technical support send an email with

the model number of the product and a

detailed description of your problem to:

Email: [email protected]

Accessories Service Center

15

EN

Warranty

Technical Support

Philips

Accessories and Computer Peripherals,

Ledgewood, NJ 07852 USA

Quality assured in USA

Printed in China

16

EN

Title

Page is loading ...

Specifications are subject to change without notice

Trademarks are property of Philips Accessories and Computer Peripherals

www.philips.com

Philips SJA9190 User manual

This manual is also suitable for

Philips SJA9190 User manual

in other languages

Related papers

Other documents